Question about GE Profile PSW26P Stainless Steel Side by Side Refrigerator

1 Answer

Lights on but nothing works

The lights of the unit are on but the digital readouts are not working. When you push the water button the light comes on until you try and get water then it goes out and no water.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,314 Answers

Pull the unit out see if there is a panel on the back with three screws in it pull the panel off and see if its fried

Posted on Feb 15, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can't turn it on. Power digital readout doesn't work.


Mine would not turn on at all, found the contact pads for the buttons was corroded. Used an eraser and cleaned them, working good now. Of course the whole thing has to come apart to get to the contact pads.

Nov 30, 2011 | Bemis 821 000 Humidifier

1 Answer

The clean light on my kitchen aid dish washer kept blinking and would not stop. after reseting it by pushing the buttons 2-3 times it cycles though and stops. then nothing works when i push the...


The electronic control looks for a temp. rise of 2-4 degrees. If no temp.rise control assumes a heater fault and blinks clean light 7 times. Bad heater. Water fill when completed can be no less than 1/2 inch below heater. If so, water valve probably. Circulation motor not working properly. Neutral door switch. Tech sheet is behind bottom cover. Check underneath of unit for leaking or white hard water deposits. Common for seals to leak. If unit is unusually noisy, motor problem. Common after 4-5 years. Will check back to see if you other questions. Good luck.

Mar 28, 2011 | Dishwashers

1 Answer

Can't change temperature-stays on "warm"


Push the COOK TIME button, if the time changes then if you leave the number of hours between 1 and 6, and press the ON/OFF button, it will cook on high that many hours. If you leave the number between 7 and 10, and press the ON/OFF button, it will cook on low that many hours. If you leave the number at "0" then the slow cooker will cook on WARM. If the COOK TIME button does not work, unplug the slow cooker, hold both the ON/OFF button and the COOK TIME buttons down and plug it into a wall socket. After the lights flash a few times, release the buttons. the switches should work.

May 19, 2009 | CorningWare SC60 Slow Cooker

1 Answer

240V wall oven,digital readout and oven light come on but no heat


Bad clock assembly although the clock works the solid state switches internally typically go bad even on brand new ovens,does broil work,the top elements should work?

Jan 21, 2009 | Ovens

1 Answer

Microwave Stopped Running


Sounds like you have a problem with the keypad or controller, or possibly bad door switches or mounts.

In any case, for your convenience we have posted the entire service manual at our site:
http://www.microwavedisplay.com/R1870_R1871_sm.pdf

I would also suggest you look over our door switch file at http://www.microwavedisplay.com/doorsw.txt

If you need further help, feel free to contact me directly or reply back.

We're happy to help and we appreciate your thoughtful rating of our answer.

Mar 20, 2008 | Sharp R-1870 Convection/Microwave Oven

2 Answers

Kenmore dishwasher


needs a new control panel/ touchpad assembly very easy solution!!!chat with me online and ill step you through it save up to $65 (my in-home rate in florida is $75!!!!!!!)

Sep 27, 2007 | Dishwashers

2 Answers

Red warning light does not go off


use the end of a turkey baster to push water through the hole in your water bucket....do this a few times while having the hot water nozzle on. This fixes it for me.

Oct 17, 2006 | Saeco Vienna Espresso Machine

Not finding what you are looking for?
GE Profile PSW26P Stainless Steel Side by Side Refrigerator Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

KJ4QOB

Level 2 Expert

55 Answers

Alan Moore

Level 1 Expert

25 Answers

Gerardo Ahuactzin
Gerardo Ahuactzin

Level 1 Expert

24 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...