I HAVE A DIMAGE 600 WHICH DO NOT COMPLETELY OPEN OR CLOSE. IT KEEP DISPLAYING ERROR SYSTEM S0042. WHAT THIS MEAN AND HOW CAN BE FIX? I WILL APRECIATE YOUR HELP, THANKS.
the cover is open, lenses are out and don't move. while trying to turn on (moving the door slightly) screen turns on, shows a picture for a sec, or less and error s0042 apears along with beeps. can hear sounds of lenses trying move. pushing on lenses doesn't work.
An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: error code S0042, DIMAGE G600
The S0042 error code relates to a problem with the zooming mechanism (lens would not retract or extended) Press the power button on and hold it down while extending and twisting the telescopic zoom lens. It might fix your problem. Let me know if it worked!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This error code indicates that the door needs to be opened and closed. The F26 code may appear the first time you try to use the washer. Open and close the door to clear the display. The F26 code may also appear if the washer has run three cycles without the door being opened. Open and close the door to clear the display. If opening and closing the door does not remove the error display, press Pause/Off or Pause/Cancel twice. If Pause/Off or Pause/Cancel does not work:
Unplug the washer or disconnect the power for one minute.
Plug in the washer or reconnect the power.
Re-select the cycle and press Start.
NOTE: If the error remains on the display, and the condition above has been checked, call for service.
Check that ALL of the covers / doors are closed completely. If they are not closed completely and securely, the safety switch will not close and the printer will not work - and displays the error. Since the error is "rear door jam" check the back of the printer...a door panel may have popped open while you were working on installing the memory.
What you can do is to powerit on and try to pull the lens out manually. Do not use too much strength or rotate. But try it a few times and the lens casing may stop touching the camera body. Once the lens comes out fully then the camera will boot up and work.
I have already answer to this problem. To try on solve it you need to remove the metal front cover and check if the socket of the large flat coming fron the back of camera is complete inserted on his shell, or if you damage the cable because the camera drop down
your lens mechanism is stuck up! try pulling the lens with slight force, if you are lucky the culprit that is blocking the mechanism will get loose. If you are not lucky theres no way you can remove or fix the problem than sending it to the authorized service center. =-(
I had this problem with my 600. I noticed that the end, center, part of the focusing mechanism was slightly out of alignment. (The part that usually sticks out furthest.) Once I straightened that piece, it was able to retract and the camera could be closed. Look at the focusing mechanism from all sides to make sure it is straight. The part was very slightly off, but enough to cause the error. My camera has been working fine since.