Question about Whirlpool RBS275PD Electric Single Oven

3 Answers

Whirlpool Supercapacity 465 Oven (RF396 LXE2) Door Problem

The oven door came off while moving. We have tried everything we can think of to put it back on with no success. Can you explain how it goes back on ?

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 123 Answers

For normal use of your range, you do not need to remove the door. However, if you have to remove the door follow the instructions in this section.
NOTE: If the door removal pins included in the Anti-Tip Bracket Package are not available, nails or screws may be used. Be careful that the length of the nail or screw does not damage the oven by chipping or scratching the porcelain surface.
To remove:
1. Open the door about halfway. Insert removal pins into both hinge hangers. Do not remove them while the door is removed from the range.
2. Close the door as far as the door removal pins will let you.
3. Rotate the door toward the range. Lift up the door until it stops. Do not use the door handle to lift the door. Rotate the door toward the floor and pull it toward you.
REMOVING THE OVEN DOOR (CONT.)
To replace:
NOTE: The door removal pins you inserted must still be in both sides of the door.
1. Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.
2. Rest the hinge hanger so that it is flat (at the bottom of the hinge hanger on the bottom of the front frame slot).
3. Position the door with the hinge hanger slots almost parallel to the front frame.
4. Push up and in until the hinge hanger slots become fastened to the range. Lower the door and rotate it slightly from the front to the back until the slots are fully fastened. The hinge
hanger will be close to the bottom of the front frame slot.
5. Pull door open about halfway and remove the door removal pins. Save door removal pins for future use.
6. Close the door.

Posted on Feb 13, 2008

  • PRIYABRAT  PATTANAIK
    PRIYABRAT PATTANAIK Feb 13, 2008

    visit the link for your manual
    http://www.samsservicesenter.com

    Good Luck
    Was this solution helpful? Show your Appreciation by rating it:

  • PRIYABRAT  PATTANAIK
    PRIYABRAT PATTANAIK Feb 13, 2008

    try this this will solve your problem

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,314 Answers

1. Open the door half way and install a nail or a screw into the hinge hanger holes on
both sides of the door. let the nails rest against the door to hold the hinges at the proper angle grasp the door on both sides and insert them into the slots and hook the the pins in the slots with the door hinges and let it down open the door all the way and remove the nails that should do it

Posted on Feb 13, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 155 Answers

These are the instruction on how to remove and replace the door, be sure you locate the removal pins to being able to put it back

Whirlpool Supercapacity 465 Oven (RF396 LXE2) Door - ddfb42d.gif
c1ea506.jpg

Posted on Feb 13, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can I do for F5-E1 situation


Check this article as the cause could be the control board, the door lock mechanism or the Membrane Keypad!


Whirlpool Oven Common Problems and Causes

Jan 08, 2015 | Ovens

1 Answer

The F5 error code?


WHIRLPOOL
Range/Stove Oven Fault Codes, Common Failure
Code
Condition Check/Repair Digit Failure Code2 F1 Analog to Digital Failure Disconnect for 30 seconds - if display reappears - replace control board F1 Safety flip flop Replace board F1 Shorted keypad Replace keypad F3 Oven temperature sensor opened Replace oven temperature sensor F2 Oven temperature sensor shorted Replace oven temperature sensor F3 Oven too hot Replace oven temperature sensor F3 Clean temp too hot Replace oven temperature sensor F5 Check door/latch switch Replace switch if defective

Nov 03, 2007 | Whirlpool GBS307PR Electric Single Oven

1 Answer

The oven locks automatically when the auto clean tab is pressed . it takes too long to open . I need it to open now , How? My Whirlpool oven is superpower 465


THE DOOR LOCKS TO PREVENT SOMEONE GETTING BURNED DURING THE EXTREME HEAT PRODUCED DURING THE SELF CLEANING PROCESS.UNPLUG THE OVEN, IT SHOULD RESET ITSELF. BE CAREFUL

Jan 06, 2011 | Whirlpool Ovens

1 Answer

Whirlpool Super Capacity 465 oven won't turn on


My Whirlpool Super Capacity 465 oven

Mar 15, 2010 | Ovens

1 Answer

How do you put a door on a whirlpool gas super capacity 465


The hinges on OVENS usually fight you trying to install the door.

The trick is that you bring each hinge down and put a nail through a little hole that is usually provided to hold the hinge open.

Jul 25, 2009 | Whirlpool SB160PEE Gas Single Oven

1 Answer

Whirlpool self cleaning oven, Super capacity 465, door will not close


I had the same FSE error which the whirpool web site advises that you will need to schedule a service appt to fix. Instead I leaded against the door while initiating the cleaning cycle and the door locks and oven cleans fine.

Jul 03, 2008 | Ovens

1 Answer

Whirlpool RF396LXE2 Oven


i posted the solution under premium problems i don't know how that works but what you have to do is get a couple of nails pull the hinge on the door down far enough to insert the nails in the holes and let it rest against the door this will hold the door at the proper angle to engage the hooks inside the hinge slots on the body of the range grasp the door on each side and insert the hinges in each side to engage the hooks then open the door all the way and remove the nails

Feb 13, 2008 | Whirlpool RBS275PD Electric Single Oven

1 Answer

Whirlpool super capacity 465 timer won't beep


clock timer and motot for a black electric oven 220Volt. oven number on plate at bottom of door is these two RGE 1600 P 5.8 and MK 93877451 4.4












rge

Jan 12, 2008 | Whirlpool GBS307PR Electric Single Oven

Not finding what you are looking for?
Whirlpool RBS275PD Electric Single Oven Logo

629 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Ovens Experts

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

 Fix Your Board
Fix Your Board

Level 3 Expert

310 Answers

John Tripp
John Tripp

Level 3 Expert

4654 Answers

Are you a Whirlpool Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...