Question about Speakers & Subwoofers

2 Answers

Reciever Problem On my JVC RX-6008V the display comes up "Overload" I checked the speaker wire, the wire was good, i checked the speaker, it was good. I even tried switching speakers and it still doesnt work. It usually happens when i try to turn it up. So i figured it was an internal problem.

Posted by on

  • Destruction Feb 12, 2008

    Theres a lil more to this problem, i'll run the Test on the speakers, and it usually states "overload" on the Left Front speaker, never any of the others, and thats with any speaker running in the left front

×

2 Answers

Just dont turn it up so loud and it'll never give you problems. I have the same exact receiver.

Posted on Oct 28, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 238 Answers

Hi, its definetly an internal problem, commonly in the output section, usually its a capacitor or an transistor which is leaky or short. which causes the overload, so u will need a techinical hand to get it resolved.

Posted on Feb 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi...i have a JVC RX-664VBK reciever and i have to turn on and off a dozen of times cause its always showing the " overload"...can i have help on resolving this problem?????


Power cycling will not solve anything and may eventually stress whatever is left of the power supply to death.

Generally speaking, an amp attempts to protect itself from heat, shorts, overloads and operator exuberance by refusing to turn on or stay on.

Overloads can be from excessive periods of high output or marginally low impedance loading by the speakers; and shorts would be wiring issues or a speaker blowing up.

You should be able to feel if it's hot. WHY is it overheating? Make sure it has sufficient ventilation on all sides and that vent holes are not blocked by dust balls. Ensure the fan (if equipped) is running as designed (some only operate on demand). Clean dust and debris from it.

If the amp comes back on after cooling, you're lucky. They only have so many self-protection cycles in their lives so continuously resetting or cycling their power without addressing the cause can do more harm than good.

If it protects immediately on a cool power up you should disconnect the speaker connections and try it 'naked'. If it comes up then diagnose which lead(s) are shorted. If it does not come up the problem is internal and should be left to an experienced and competent hands-on tech.

Check for loose speaker connections at the speaker as a root cause for intermittent shutdown.

Apr 19, 2011 | Speakers & Subwoofers

1 Answer

Need jvc rx518v wiring diagram so I can get surround to work right


The JVC site doesn't list that model

http://books.jvc.com/booklist.asp?Model=rx-5

but I imagine it can be a whole lot different frrom the RX-554V

Jan 22, 2011 | JVC Speakers & Subwoofers

1 Answer

Can I hook these directly to my TV


No. The jacks on the back of your tv are line level. That means no power. To get the power, you need a reciever. Red and white RCA wires will go from your tv's out and the other end to an input on your reciever, and your speaker will be wired to the speaker out jacks on your reciever.

Nov 14, 2010 | Jensen JP1200 Main / Stereo Speaker

1 Answer

I have a new house that had speakers built into the cieling. I bought an onkyo to push all eight speakers. the reciever went into protect mode. i had an old reciever and hooked four speakers to the onkyo...


you can check them with a ohm meter, hook it to the wires that you hook to the reciever and if you get a reading it is good if no reading it is bad wires

Nov 22, 2009 | KEF Audio Cresta 2 Speaker

1 Answer

How do i properly connect the wires for a JVC SX-SW5th


Connect the speaker output of the reciever to the input of the speaker. Make sure you connect negative receiver output to negative speaker input and positive receiver output to positive speaker input.

Sep 15, 2009 | Speakers & Subwoofers

1 Answer

Hooking up a klh PSW8-100 sub wofer


Hey you might find a solution on this audio and wiring blog: www.audioholicblog.com -- it has a blog about wiring your home audio system and the cables that you will need.

Hopefully this helps! Good Luck!


Dannyboy!

Sep 20, 2008 | Speakers & Subwoofers

2 Answers

Jvc home stereo subwoofer


just chek the cables.. f it not work open the sub box , and check the sub speaker., , , , maybe the wire is burnd

Mar 01, 2008 | Speakers & Subwoofers

1 Answer

Connecting Bose 901 Series VI Direct Reflecting Speakers to JVC RX-8020VBK Receiver


in order to make those speakers sound good (if they can sound good at all) you need to use equalizer box witch came with them. If your receiver does not have tape monitor loop or preamp to amp jumpers you can not use those speakers. To be honest you do not loose much... none of this stuff is any good (sorry for bad news), but if you like those speakers (I know they have big fans, even if in HI-FI world, they not consider as good) you have to change you receiver. Dariusz


Feb 13, 2008 | Bose 901 VI Main / Stereo Speaker

1 Answer

No sound from subwoofer


have you checked for the continuity of the wirings? check for the resistance of your speaker from it jack..... it should measure close to 8ohms or 4ohms using a digital multimeter (DMM). check also the sub out jack of your reciever if there is a signal from it using your main speakers if they come with jacks also (turn the volume low to prevent damage to other speakers you connect on it!

Nov 07, 2007 | Tannoy Sensys 7 Speaker

Not finding what you are looking for?
Speakers & Subwoofers Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Speakers & Subwoofers Experts

 Grubhead
Grubhead

Level 3 Expert

4590 Answers

Michael Edwards
Michael Edwards

Level 1 Expert

53 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...