How can I make fuel injectors fit for 94 325.i 2.5 L6 BMW

if the plugs are wet it shows extra fuel is getting in. remove and check the faulty injectors and fit new seals when refitting the injectors.

Hey Chuck, run a bottle of fuel injector cleaner in a full tank of gas and see if that takes care of the problem.

There is no solution other than to get the correct injectors. The ohm ratings are not even the same. They are close but close is not good enough for fuel injector PCM drivers they must be with in BMW spec. Should these Ford injectors be on the low end of the scale they will run the BMW injector driver circuits hot and fry them.

15-17 ohms BMW
11-19 ohms FORD

usual problem ,valves in injector worn for the fuel pump.easy quick fix this one ,fit a non return valve in the inlet pipe,check flow direction on valve when fitting and evan better as well is another in the bleed off return pipe .valves available from a motor factor or a specialist garage like bosch or lucas ,cut pipe and fit the valve with a piece of rubber pipe to connect the valve in line.or listen to the people who want to milk the golden cow and have the whole injector pump overhauled .

Check the pulse on the two injectors.Purchase a noid light at the parts store,that will fit the injector harness,see if the noid lights will flash,if they do,then replace the injectors,this would be the only thing it could be.If the noid light is not puling,or flashing,then the computer is the problem,seeing it is the distributor of the pulse on time.

Hello,
You will need to check your fuel pump and your injector nozzle in the engine. You will also need to check that you have enough fuel and your fuel indicator is working well. Injector engines usually do not tolerate low fuel levels. As for the cost of change, it will depend on where you are and what type of auto mechanic you are dealing with.

Cheers

Hello There

These are very common codes on BMW's which can also be false codes, try clearing the codes and run the test again they may not come up again.
With regards to the sound which you thought was a vacum leak there a breather pipe which runs under the plastic engine cover near the injectors which always gets a tear init which will need replacing.

Hope this helps, please don't forget to rate me.