Question about Hotpoint NVL333EY Electric Dryer
Can some one help me with some advice please. My dryer is working as it should but is not producing any hot air at all. Can some point me in the right direction please.
I don't know Hotpoint models but I do know Malber models very well which also have a condensing dryer. The dryer has a fan and a heating coil or heating element, similar to a hair dryer. If you are getting no air flow, then it could be the fan. If you are getting air flow but it is not hot, then it is probably the heating element which burnt out. In the Malber machine, the top cover comes off and you can see an aluminum duct on top with two terminals sticking out the side. These two terminals go to the heating element inside the duct, and the heater element is like the heating element in an oven. You have to remove the duct and then it splits into a top and bottom half, and then you can remove the heating element to replace it. The way to tell if it is bad is to run the machine in a dry cycle and see if there is 110 volts across the heating element terminals. If there is power, but no heat, then the heating element is bad. That element is usually the first thing to fail.
Posted on Feb 12, 2008
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Oct 03, 2016 | Hotpoint tcm570p Aquarius Condensor Dryer...
Mar 05, 2015 | Hotpoint tcm570p Aquarius Condensor Dryer...
Jan 18, 2010 | Hotpoint Aquarius WD63 Front Load...
Sep 15, 2009 | Hotpoint Ariston Aquarius WD420 Front Load...
Jun 24, 2009 | Hotpoint Ariston Aquarius WD420 Front Load...
Aug 11, 2008 | Hotpoint Aquarius WD640 Front Load...
May 09, 2008 | Dryers
Mar 09, 2008 | Dryers
334 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: