Dell latitude 110L doesn't start, blinks 9 times

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.
Check the lamp ballast too.

If your laptop appears to boot up and the hard disk LED flashes, then the problem is probably a back light fault. This can be a faulty inverter or a faulty CCFL lamp. Please click on this link and follow my instructions to identify the fault and possible fix :- http://www.fixya.com/support/r3598095-faulty_laptop_lcd_screen

When the LED blink for couple of times and goes off its hardware problem with the computer... It might be a motherboard or the RAM that is causing this problem... Please take the computer to a local tech or call dell at 18006249896 to get the issue fixed

hi

go to following link you will get password recovery details

http://repair4laptop.org/laptop_and_notebook_bios_password_reset.html

Please perform the steps mentioned in the link below:

No Power troubleshooting

AND

No POST

1. Disconnect power supply
2. Remove battery
3. Wait 30 seconds
4. Reïnsert battery
5. Reconnect power supply
6. Try to boot again
   

1. Disconnect power supply
2. Remove battery
3. Wait 30 seconds
4. Reïnsert battery
5. Reconnect power supply
6. Try to boot again

http://support.dell.com/support/downloads/driverslist.aspx?c=us&cs=19&l=en&s=dhs&ServiceTag=&SystemID=LATITUDE%20110L&os=WW1&osl=en&catid=&impid=

All drivers for you dell is in the above link.

Thanks

Please donot forget to rate fixya.

in Windows 95, 98, ME, and XP
start in safe mode F8, go to control panel, users, remove old password

it is a bad fan. it also could be a power supply. Quite often the real problem is dirt clogging up the fan(s) to the point that they need to be replaced. Operation of the set in a dirty environment is not a good idea