How do you change the clock settings? - 2006 Dodge Dakota

Somewhere on the lower part of the dash, you will find a small thumbwheel that increases the brightness.

It might be shown in here. 'Year make model' are important.

Press the power button. Access the clock via the menu button. Finally press the dash buttons that are located right under each display to set the hour, minute, month, day, and year on the 2013 silverado.

Try the owners manual?

I don't know what your dash layout is but you must be able to set the clock time.

If the clock display is in the hooded centre dash panel press set for more than one second to enter clock/date menu then press set briefly to move through the settings. Try pressing H and M at the same time to change from 12 to 24 clock.

What question

Hold Clock to get it in the set 12/24, tap Set to move to 12hr, tap clock to move to the hour, tap set to get to the right hour, tap clock to move to the minute, tap set to get it to the right minute, tap clock to back out of it.

Make sure the clock is set to the correct time zone before trying to set the time.

Hello, here is the instructions for setting your clock on this vehicle.


Press the H or the M button to enter the clock mode. Press and hold H until the correct hour appears on the display. Press and hold M until the correct minute appears on the display.
To change the time default setting from 12 hour to 24 hour, press either the H or the M button to enter the clock mode. Press the tune knob to select between the 12 or 24 hour display format. The clock mode automatically times out with the changed display format set as the current default setting.

To set clock . You need ignition switch in the on position .Now look at the radio's display on the right side there two round spots marked H and M. With a ball point pen press H to set the hour and again do the same thing with the M to set the minutes. Now clock is set

kavtrom to reset the clock you use the instrument cluster by navigating the steering wheel multi function keys untill cluster states settings-after you have set the time while the instrument cluster multi function screen is still at the clock settings you have to press the the reset button/dimmer knob on left side of instrument cluster and the clock will go backwards until 9-10 oclock and then will forward itself to the correct time

There are two depressions just under the clock, pressing one with a ballpoint pen changes the hours, the other changes the minutes