Hello, I bought my camera on line so no warranty. The camera takes beautiful pictures. Every function works except the zoom. Whenever I push the zoom out the camera displays "turn the power off and on again" I have done that a few hundred times and it never works...but I always keep hoping...I hope someone can help me.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
When you switch the camera from mode to mode, does it make the click noise to signify that the camera recognized that it changed modes?
If not it could be that the switch itself has become unlogged from the switch. I know I had a older camera had this happen before. Try pushing down hard on the toggle wheel and seeing if it will snap back into place.
Otherwise the switch inside the camera itself is probably broken, and if this is the case cheapest thing you can do is have Sony do warranty work on the camera.
Click repair and service under Technical Support. This will get the process started on the warranty work.
You need to replace flash bulb board of DSC-H1 as shown in below image. (item # 304) Part number is as follows.. A1119331A ST-124 BOARD, COMPLETE It is available in Part Store. Replacement of ST-14 board (flash bulb board) requires expertise and solder work. Thanks.
I actually have the exact same problem with the Sony Cyber-Shot DSC-H9 It says Access because it's strugglign to read the media card you have in it. Sometimes trying a different card works, but it likely needs hardware repair. mine is in the shop for the 2nd time with the same problem.
Hello, Put camera in Auto mode (green mark) on Jog dial at top and there is control / navigate switch near LCD, check upper button, it has Flash sign / mark on it. Press this button and observe Flash mark(yellow) in LCD. Flash is ready now and take picture. Need further help, let me know.
are you sure that there is no conversion lens setting activated in the setup menu? It sounds like that to me. These modes limit the ranges.
I hope it will help, otherwise you will have to bring it back.
The W12 must be a European version of the W1 or W5 camera. The W12 is not available in the USA.
It sounds like you have the "digital zoom" feature active.
Digital zoom lowers the quality of the photo.
It (in effect) reduces the megapixels applied to an area of a photo.
Digital zoom should not be used if you want quality results.