INSTRUCTIONS NEEDED FOR THE SHARPER IMA...

click the link http://mscustomercare.com/ scroll to the bottom of the page and download instructions for jumbo remote.

I have the instructions and still cannot get the Scientific Atlanta Explorer 2200 coded. It will not learn any codes from the cable remote either.

I went to your website because it was advertised "FREE" and noticed I would have to pay instead, so I said to heck with it,,,,,I could buy another remote control a lot cheaper.

The "auto" mode isn't quite presented correctly in the documentation or posts I've seen...after MUCH trial and error (and about 3 hous) I've been able to set-up ANY infrared device, either by "auto" or learn. (Although maybe not "fully".)

AUTO Method

1. Press & Hold (about 3 sec.) the [DEVICE] button on the JUMBO Remote....llight will stay solid.
2. Now just press the [POWER] button (only) ONCE while pointing at the device...it will start sending codes approximately every second. (Don't keep pressing the power button as instructions indicate.)
3. TIMING IS EVERYTHING HERE. (It may take 5 minutes to find your devices code.)
4. AS SOON AS the power goes off...press the [ENTER] button on the JUNBO Remote.
5. Now pressing the [POWER] button should power up/down the device.

---- any buttons not programmed will have to be handled using the LEARN method ---

LEARN Method

1. Press & Hold (about 3 sec.) the [DEVICE] button on the JUMBO Remote....it'll stay solid.
2. Press the [LEARN] button on the JUMBO Remote. (light will immediately blink rapidly.)
3. Now Press the {NEEDED} button to program. (light will stay solid)
4. Now (1 to 2 inches away) have the ORIGINAL Remote pointed at the JUMBO Remote and press the {DESIRED} button on the ORIGINAL Remote.
5. It blinks rapidly while sending...then a slower steady blink once "LEARNED" correctly.

*** Not all buttons work properly with the "LEARN method". Some you will need to "associate" with an alternate button on the JUMBO Remote. ***

I sincerely hopes this helps anyone & everyone.

- turn device on
- press and hold code search button until red light blinks
- press the device button you wish to program
- press the power button and release. Do this repeatedly (pausing 1 second in between) until device shuts off.
- press and hold enter button for 5 seconds.

Test device

Here is a direct link to the PDF of the Instruction Manual:

http://mscustomercare.com/forms/JumboRemoteEM_InstructionManual.pdf

codes: 506,311,612,002,428,802,412,619

Here you have the manual (I scanned it myself).

http://rapidshare.com/files/202369180/SharperImage-JumboRemoteControl.pdf.html

Regards,
Mario

i have the sharper image jumbo universal remote control. i need to program my television. i can't find the instruction that is needed to use the proper code for a zenith TV. help!!!

Solution #5 by guest worked for me. Thanks guest!!

i need proper 3 digit code for a tv olevia can u help me?