Question about Smeg Dishwashers

1 Answer

Smeg ST660 not starting

How do I reset a smeg ST660.
Machine is still in new condition has had part replced under recall repair was reset. but when turned on only one light comes on far right hand , should be two???

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers
Re: Smeg ST660 not starting

Switch the power off. Remove the 'built-in cupboard' panel from the front of the dishwasher and you should see the end of the timer spindle. With the power off you can turn this clockwise using another appliance knob or carefully with pliers. I think one 'start' position is with the flat section below the centre and horizontal. If the two lights are not on then try the 'start' button second from left to advance the timer.

Posted on Feb 19, 2010

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

How do I reset the code.the lights are lit 4 hour delay, rinse only steam clean.

THIS DISHWASHER WAS RECALLED BY MAYTAG.. You might want to call them to see if it is still covered.
If already repaired you might try:
Normal - heated dry - normal - heated dry. then try to use the machine.

Oct 19, 2015 | Maytag MDB7809AWB - MaytagR JetcleanR Plus...

1 Answer

Help my SMEG dishwasher was stuck in a loop and when resetting it was going through the motions like it was trying to drain itself and then finishing the cycle so all 4 lights on the right were flashing...

completely unplug it for several minutes. if you do not have a plug, turn off the breaker to this unit for about 15 minutes. Then turn it back on and see if this resets it. Check for a reset button somewhere under the unit or on the door panel where the control buttons are if this is easier.

Mar 04, 2015 | Smeg Dishwashers

1 Answer

No power after blocked drain dishwasher

Reset it by turning power off to it or unplugging it for a minute. If it still wont work then you need to take the kick panel off and see if there is leak under the machine.

Feb 08, 2014 | Smeg Dishwashers

1 Answer

Hi I have a SMEG D1612CA9 intergrated dishwasher. Last night during the cycle the pump which takes the water away has remained on stopping the cycle continuing. The first light has come on and whenever you...

You need to disconnect the power and the hoses.
Also unsrew the machine from the cabinet to pull it out.
When you have pulled the machine out, put some towls on the floor and tilt machine on its back. You will notice a lot of water come out the base of the machine.
This will reset the flood switch which has been triggered.
Reconnect the hoses while the machine is out and run a cycle. You have a water leak so you need to find out where the leak is from. In Smeg dishwashers, the most common item is a burst drain hose. Normally where it comes out the back of the machine, the hose bends and tears as it pushes against the back wall.
Remove the from kick panel and look inside the base for leaks while machine is running.

Sep 10, 2011 | Dishwashers

1 Answer

As the dishwasher was finishing its cycle - up to drying - three small explosions occurred accompanied by the smell of burning. We turned the power off. Is it repairable or is it time to get a new...

well its up to u about getting a new one but it sounds like the heater element burnt into but yes it is repairable but at what cost unless u can repair it your self u may be able to save money on repair costs if u have to call a repair man then it may be more cost efficient to just get a new one since that unit is that old

Jan 21, 2011 | Smeg Dishwashers

1 Answer

Smeg DI 612 C Domestic Dishwasher

I was told by a SMEG engineer that I needed to replace the detergent dispencer. Just waiting for him to get back with a new one.

Aug 15, 2008 | Smeg 24 in. DWI612 Built-in Dishwasher

1 Answer


just possibly
take the kick panel off. On some smeg, there is a small suppressor capacitor on the lhs tucked in the wiring. this breaks down. snip it off - no need to replace

Jul 18, 2008 | Smeg 18 in. DWI410 Built-in Dishwasher

1 Answer

It's stuck on Bio...

Here is the link to the user manual, hopefully this solves your problem else please ask again; Hope this helps :)

Jun 25, 2007 | Smeg 18 in. DWF410SS Slim-Line...

2 Answers

Smeg dishwasher

Hi, You can download SMEG dishwasher manuals from here: Al.

Feb 02, 2007 | Smeg CSU2001 Built-in Dishwasher

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

1,020 people viewed this question

Ask a Question

Usually answered in minutes!

Top Smeg Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Starnley Johnwells
Starnley Johnwells

Level 3 Expert

1029 Answers


Level 1 Expert

25 Answers

Are you a Smeg Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides