Thw washer fills with water when off - Whirlpool Duet GHW9150P Front Load Washer

The water in the washer bottle may be frozen. Put a low temp washer fluid in when it's cold.

you can put the extraction pipe /drain hose to ground level and water will drain then should open vacume switch thw programer is at fault as the programe sticks

Hello , iwill try to help you with your washer problem.. so your washer fills up and when lid is engaged with a screw driver into the lid switch thw washer makes noise like its agitating but is not agitating or spinning sound like your ( coupler has gone bad .. A coupler is kinda like a belt it syncronises the transmision to the motor it is part #285753a around $20.00 dollars on the parts break down it is item number 13 check under the washer for black rubber pieces if you need step by step instructions you can always call me for phone technical support...dr.appliance

For windshield washer water level, the sensor is inside thw washer bottle.

It sounds like one of the automatic water fill valves in the machine is leaking water when washer is off and the valves are closed. There are two manual water supply valves at the wall behind the washer, one for hot water and one for cold. Close the manual hot water supply valve and allow the washer to sit and see if it fills with water. If it does fill, then the cold water automatic fill valve is leaking. If not, then open the hot water manual supply valve and close the cold water manual supply valve. Allow the washer to sit again and see if it fills. If it does then the hot water automatic fill valve is leaking. Replace the leaking valve in your washer. You can order the new valve online using washer brand and model number on a appliance parts web store, or maybe even find it at a local appliance parts store.

You need remove and clean the filter.
Remove lower rear panel\ of washer.
Removel arge black hose fastened to bottom of drum.
Remove and clean filter inside hose.
Remove hose onto pump, and check for obstruction here and in the pump.
This should solve your problem
Thankyou.

Every machine is wired differently. It's possible but not likely that it has a fuse in the circuitry. My guess is that the level sensing tube is blocked and the washer thinks it is at the preset level, ior that the sensing tube has a leak in it. Similar to a hole in a straw. The washer can not advance and operate in automatic if its preset is not satisfied. The preset here is wherever you or it sets the level. Once thw washer fills then a contact closes and turns the timer motor on and advances the timer.

Check your hot and cold water supply hoses for residue buildup that restricts the flow of water.....there is a small metal screen filter that clogs up ....most likely the cause if your pipes are old and the inside walls are shedding deposits into the water line.

i am a recently retired engineer of 20 years and this sounds like a blockage to start with, when you remove the lid you will find a round disc like object (pressure switch) with a thin pipe coming from it going down to the bottom end of the machine, this pipe as either come off or is blocked somewhere. drain the machine totally, clear out the pipes, make sure there are no damaged parts to the pipes, then make sure all are fitted properly, start the machine off again and watch for water level shutting off near the bottom of the door, start with the above, if this doesn't cover the fault there may be an issue with the timer or electrical fault elsewhere/? hope this helps, if so rate me please, thank you