Question about Car Audio Receivers

1 Answer

Stereo code cant get code for a car i just bought it is 2000 mitsubishi eclipse

Posted by on

1 Answer

If you can't get the code (or if you lost the card that comes with the stereo) you'll have to replace your stereo receiver or contact the manufacturer / authorized service center.

OR you can replace the EEPROM memory that stores the code with a memory that has a known one ;) .

Posted on Feb 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can i get a free code for 2000 eclipse gt


In the USA anyone can get their radio code for free direct from Mitsubishi by telephone. You will need the following information:
Last 8 characters of your VIN # Radio Serial Number
Call Mitsubishi:
1-888-648-7820, option 1, option 4 Current hours: 6am to 5pm Pacific, M-F.
Tell representative that you replaced your battery and now need your radio code. If you are not currently a registered owner, they will ask for your info for registration. ==============================================================
If not in the USA then sorry....Main MITSUBISHI Dealer or Radio Decoding Service only for this code
It will not be available for free or cheap from anywhere on the Internet
=======================================================

Jun 28, 2011 | Mitsubishi Car Audio Receivers

2 Answers

Mitsubishi Eclipse Spider Gt-S I cannot figure out how to get the fascia panel and face plate off of the radio to get to the numbers needed to retrieve the radio code. How do I take the panels OFF?


Hi

The stereo in the Eclipse can be removed with nothing more than a Phillips screwdriver

Disconnect the negative battery cable from your Eclipse's battery. Remove the two Phillips screws along the bottom of the radio/climate control trim panel. Lift up the bottom of the trim panel to unlock the lower retaining clips. Work your fingers around the sides of the panel to loosen the other clips and remove the panel. Remove the four Phillips screws holding the stereo in place. Slide the stereo out of the dashboard and disconnect the wiring harness and antenna cable from the back of the device.

Also check this link if it helps:-

http://www.ehow.com/how_5938157_remove-eclipse-car-radio.html

May 04, 2011 | Mitsubishi Car Audio Receivers

1 Answer

I would like to ask what are the things needed to replace my single in dash stereo with a 6 cd changer rockford fosgate stereo? My car is 2008 mitsubishi eclipse gs.


what you will need is

1 new radio
2 dash kit
3 wire harness
4 antenna adapter
5 maybe a radio interface to adapt the new radio


caraudioquestions@gmail.com
online store comming soon

http://www.tintingbyfredjohnson.com
can ship you any thing you need take visa master card

Oct 14, 2010 | Mitsubishi Car Audio Receivers

1 Answer

I own a mitsubishi eclipse gt 2000 i had to disconnect the battery now the stereo is asking for a code. does anyone know the code?


for stock radio codes, check your owners manual front page or towards the back, normally the code will be written there, if it is not a stock radio call the manufacture and tell them the serial number and model number they can get you a generic code for it, or tell you what to press to reset it. hope this helps

Jun 03, 2009 | Kenwood KDC-MP4028 CD Player

1 Answer

How to unlock a eclipse cd5423 stereo


ATTN: All AVN units do not have an Electronic serial number, will need
to physically pull out unit to get serial number and make sure unit is
registered
Please have the following information before calling the Service
Department at (1-888-557-8278):
• Dealer account number {Applies to Eclipse Dealers ONLY}
• Customer First and Last name.
• Model Number.
• Serial Number
They charge $25.00 for security code good luck..

Jan 09, 2009 | Eclipse CD3422 CD Player

1 Answer

Radio code


need a radio code for a mitsubishi eclipse 2000

Aug 13, 2008 | Kenwood Sirius KDC-MP425 CD Player

2 Answers

2001 stereo code.


The stereo's ESN Feature has activated. High-end Eclipse stereo's have a feature to prevent theft where if the battery is disconnected from the stereo, it must be "unlocked" with a "key" CD, that comes with the CD player but can later be changed to a personal CD of the owner. You would need to either call Eclipse and see if they can de-activate it (you'll need to ship it to them, if they even do it, because it is a security feature after all.) Or you need to talk to the last owner of the vehicle and have them unlock it.

Jul 26, 2008 | Eclipse CD8445 CD/MP3/WMA Receiver

2 Answers

Eclipse 54400


the unit is locked up eclipse has a feature called esn or eclipse security network. you use a cd to program a passkey that only the owner knows. then if it is stolen the unit is useless. unless you know the right cd cool huh? if the unit is registered to you they will help you unlock it but if not they wont. cool huh. kinda makes you feel good that even if someone does steal your radio they cant use it.. ever.. eclipse also offers a one year theft guarantee out of the box if you register it with them. cool huh..

Feb 21, 2008 | Eclipse 5440

2 Answers

I need help


contact on your car dEALER....and ask for you pass code or stereo code....:)

Dec 14, 2007 | Eclipse CD8445 CD/MP3/WMA Receiver

Not finding what you are looking for?
Car Audio Receivers Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio Receivers Experts

xxxxxx xxx

Level 3 Expert

4706 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Car Audio Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...