Question about Car Audio & Video

1 Answer

Cannot figure out why my car starter will not start my car????

I have a astrostarter for my subaru. It worked last winter, and now I might have forgotten how to get my car started. I put in a new battery, and now I have no idea what to do, or where to start. It has a key button, a lock button, and unlock button, and a ? button. what should I do??

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,039 Answers

They put a valet switch to deativat the system maybe you accidently put to off position they put that switch under the stering wheel around there thanksfor using fitya pierre

Posted on Feb 07, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have an Astrostart hst5224, It will star then immediately shut off. My jeep is A manual transmission

Immediately report any malfunction to the AstroStart dealer that performed the ... Always turn off the main switch when not using the remote starter for .... The startmodule will inform you of the status of door locks, the alarm and of the engine. .... If the trunk is opened for more than 5 minutes, the system switches to the.

How do you reprogram an AstroStart remote HST5224 > Wiki Answers > Categories > Cars & Vehicles
In order to reprogram an AstroStart HST5224 remote, you must putthe key in the ignition ... lamp) b, press and hold UNLOCK button, after 1 second key LED will flash once c, .... C. Turn the ignition to ON (Do NOT Start) then back to OFF. ... B.Immediately after letting go of the lock and unlock buttons, press the lock button by ..

Nov 24, 2015 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

Subaru outback wiring diagram 2004

The aftermarket starter may be defective.

Aug 25, 2017 | Subaru Outback Cars & Trucks

1 Answer

No start just one click in 1995 buick lesabre

First-how old is the battery?

They can last 4 years or 9

You test the battery when fully charged for voltage,
then load test it

New battery or old one- you move on to test the starter

No parts every go into a car until you know how to test
them & they fail a test

So a Repair Shop is your most logical choice

Dec 27, 2012 | 1995 Buick LeSabre

1 Answer

During the past two winters I have had enormous problems starting my car. Have new battery, new starter, crank shaft sensor and many other new parts. Mechanics cant figure out what is wrong. Its as if...

I had the same problem with my Blazer last winter. I had the fuel injectors replaced and now it starts fine. If you haven't had them changed in a while that is probably your problem.

Dec 04, 2010 | 1989 Buick Skyhawk

2 Answers

I have a Command Start remote starter and the remote is worn out and buttons are terrible where can a person get a replacement remote but I dont know model number as there is no markings on remote it was...

Command Start was an AstroStart brand, you need to find a dealer in order to get a replacement remote. They do not sell via the internet. The following link will assist you in finding a dealer near you.

AstroStart dealer locator

Nov 12, 2010 | AutoCommand Remote Car Starter Add-On

1 Answer

My subaru will not start. The starter is not reacting when I turn the ignition. It is a '93 legacy wagon. I have checked all the fuses. I have checked the clutch starter switch. I checked it by bypassing...

Did you check the wiring going to the starter,Have a friend turn the key to start and see if you are getting poer to solenoid at that time,If not start working backwards to the starter relay,and finally to the ignition switch.You can check the codes by using a jumper wire under the hood on the passenger inner fender area there is a empty female connector,You should buy one of the Haynes books at Autozone for your car,It would help you alot.The last 10 to 15 pages are wiring diagrams,of lights,charging,starting.

Jan 22, 2010 | 1993 Subaru Legacy

1 Answer

97 outback legacy; won't start

not sure if this will help, but I recently changed the engine in my subaru and changed battery + starter also. Would start but then not restart once warmed up. Turns out the engine ground got forgotten, had that hooked back up after banging my head on a wall for a week and it runs like new

Apr 05, 2009 | 1997 Subaru Legacy

2 Answers

Yamaha V-Star 1100 Custom stalls when downshifting

sounds more like a fuel problem to me. is it cold there did you use stabilizer in the gas? try some berrymans B12 in the gas it cleans everything up internally. it worked for me

Mar 18, 2009 | 2001 Yamaha V Star 1100 Classic

1 Answer

Remote starter stopped working

Will you rate my answer from my clarification as a solution about the antenna thanks Mike humble.

Dec 11, 2008 | Vehicle Parts & Accessories

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4991 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers


Level 3 Expert

82322 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides