Question about Barebone Systems

1 Answer

Extract ink cartridges, in order to insert new cartridges. HP Photosmart C4200 All-in-One series

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 625 Answers

With the access door open, press down not forward on the rear of the cartridge. it should unsnap from the connector then lift it up and out.

Posted on Feb 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I no longer have my manual, how do I change the ink cartridges for the HP Officejet 6300 all-in-one?


To replace the print cartridges
1. Make sure the HP All-in-One is on.
Caution If the HP All-in-One is off when you open the print cartridge door
to access the print cartridges, the HP All-in-One will not release the
cartridges for changing. You might damage the HP All-in-One if the print
cartridges are not docked safely on the right side when you try to remove
them.
2. Open the print cartridge door.
The print carriage moves to the far right side of the HP All-in-One.
3. Wait until the print carriage is idle and silent, and then lightly press down on a
print cartridge to release it.
If you are replacing the tri-color print cartridge, remove the print cartridge from the
slot on the left.
If you are replacing the black or photo print cartridge, remove the print cartridge
from the slot on the right.
4. Pull the print cartridge toward you out of its slot.
5. If you are removing the black print cartridge in order to install the photo print
cartridge, store the black print cartridge in the print cartridge protector or an
airtight plastic container.
If you are removing the print cartridge because it is low or out of ink, recycle the
print cartridge. The HP Inkjet Supplies Recycling Program is available in many
countries/regions, and lets you recycle used print cartridges free of charge. For
more information, go to the following website:
www.hp.com/hpinfo/globalcitizenship/environment/recycle/inkjet.html
6. Remove the new print cartridge from its packaging and, being careful to touch
only the black plastic, gently remove the plastic tape by using the pink pull tab.
7. Slide the new print cartridge forward into the empty slot. Then gently push on the
upper part of the print cartridge forward until it clicks into the socket.
If you are installing the tri-color print cartridge, slide it into the left slot.
If you are installing a black or photo print cartridge, slide it into the right slot.
8. Close the print cartridge door
9. If you installed a new print cartridge, the print cartridge alignment process begins.
10. Make sure you have plain paper loaded in the input tray, and then press OK.
11. The HP All-in-One aligns the print cartridges. Recycle or discard the print
cartridge alignment sheet.
12. Press OK.

Jul 17, 2011 | Barebone Systems

1 Answer

Hi I have just inserted a new HP ink cartridge 94 into my HP PSC 2350, as the ink was running low. I was printing photos, which keept printing with a red line throughout the picture. After inserting the...


Try opening the printer properties and cleaning the print heads (should probably be done each time a cartridge is changed), it uses some ink up but should clean the build up from running the previous cartridge dry and hopefully solve your printing problem.

Good luck.

Mar 29, 2008 | Barebone Systems

1 Answer

Trying to install new hp photosmart c4200 all in one series.All goes well on installion until message pops up stating driver can not be installed because it is not digitally signed or not signed in the...


hi
go to my computer properties
then driver signing
then check 3 rd option button is true or false
it must clear.
then install driver
best of luck

Mar 27, 2008 | Barebone Systems

1 Answer

Colour prints not satisfactory


D_foofat,
This link will take you to instructions on cleaning your Cartridge Print Head: http://h10061.www1.hp.com/ccsearch/search?method=viewDocument&redirUrl=http%3A%2F%2Fh10025.www1.hp.com%2Fewfrf%2Fwc%2Fdocument%3Fdocname%3Dc00285228%26cc%3Dus%26lc%3Den%26dlc%3Den%26product%3D402150%26dlc%3Den%26lang%3Den&docId=document%28c00285228%29&uqry=&cqry=clean+printhead&ctry=us&dlc=en&lang=en&qry=clean+print+head
I hope it helps, and Good luck.

Mar 16, 2008 | Barebone Systems

1 Answer

HI,got this new hp psc 1410 i have connected with my computer ,got photos ready but when i presse print it doesnt work,pls can you help.thanks


did you install the cd driver of your Hp psc 1410?
if not insert the cd driver of your HP printer, after auto play goes click install driver, just follow the instruction on screen, then finish,
remove the ink cartridge, check if ther a cover in the contact point of your cartridge, remove the seal,

Mar 12, 2008 | Barebone Systems

1 Answer

Where is the ink cartridge located on the hp psc 2110v all-in-one printer, scanner, copier


With the power turned on.
Just above the paper try & below the scanner bed.
Lift the edge till the hole top opends like a book. The carridge with ink cartridges will move to the center of the opening. Do you not have a manual? Download it at the link here.
http://h10025.www1.hp.com/ewfrf/wc/manualCategory?lc=en&cc=us&dlc=en&product=79494&lang=en&
Download the file that reads: HP PSC 2100 Series all-in-one - (English) Reference Guide . Start on page 26 for ink cartridge.
please vote...

Feb 18, 2008 | Barebone Systems

1 Answer

Can't print in colour


Hi Paddy,
It sounds like the color ink cartridge is clogged. You can try taking the color cartridge out, and take a paper towel and some windex with amonia. Spray the paper towel with the windex and then take the color cartridge, and wipe the bottom of the ink cartridge. After wiping the bottom of the cartridge, try pressing on the bottom of the cartridge (Print head) with the paper towel...You should start seeing some ink soaking into the paper towel. If you do not see any ink on the paper towel, then try wiping it again with the windex/paper towel. If after a couple tries, you can not get the ink to flow from the print head, then I would suggest getting a new cartridge.
The HP ink cartridges can get a bit tricky and the print heads will clog when the printer is left sitting for a long period of time.
Hope this helps.
Good luck.
If you have any other questions, feel free to post them.
IF I have helped answer your question, please remember to leave a feedback and or rating for my suggestion.
Mac =)

Feb 13, 2008 | Barebone Systems

1 Answer

We just attached the macbook to the hppsc 1350v all in one printer and new print cartridges. When attempting to print, message reads"color print cartridge not compatible with this printer". We know we have...


Hi,

Just to confirm pls:
1. the new print cartridges are original HP inks;
2. you have remove the bright pink tape from the ink cartridges;
3. the black is on the right side and the color is on the left side.

You can try removing both cartridges and clean the gold colored contacts where the pink tape was. Pls do the same to the mate pins in the cartridge holder in the printer.

Try again. If this does not be corrective, you may need to change inks again.

Hope this be of help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Feb 02, 2008 | Barebone Systems

1 Answer

I have a hp all in one printer/scanner etc... it say its model C3150, which ink cartridges can i get to replace the old ones????


Hi,

The part numbers of the inks for your HP C3150 are:
HP 92 - black
HP 93 - color
HP 99 - photo

They should be available at most computer stores or if you prefer to order from HP, pls see this page..

Hope this be of some help/idea. Pls post back how things turned up or should you need additional informatiion.

Good luck and kind regards.

Jan 30, 2008 | Barebone Systems

1 Answer

Cartridge Failure


are you removing the tape from the cartridge?
and putting it in the correct slot?
is it a rebuilt cartridge?

Jan 17, 2008 | Barebone Systems

Not finding what you are looking for?
Barebone Systems Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Barebone Systems Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18298 Answers

john smith

Level 2 Expert

366 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a Barebone System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...