Taking in water then the code E11 comes up and it would not do anything.

Family error code E10 is visible to customers and (could be E11 and E13 only visible in service mode) means problem with filling water.
I suggest rapid reading alarm code when appliance is in normal operating mode (e.g. during the execution of the washing programme).
Press and hold down START/PAUSE and the nearest option buttons for at least two seconds: the LEDs initially switch off, and then display the flashing sequence corresponding to the last alarm.
The alarm sequence continues as long as the two buttons are held down.


Before anything first check filter on solenoid valve and filter on inlet hose. Also, check is there any water inside drum, means that last drain phase is finished and pressure switch is in empty position.

E11 - Tap closed or water pressure insufficient; Drain hose
incorrectly positioned; Water fill solenoid faulty; Leaks from
pressure switch hydraulic circuit; Pressure switch faulty;
Wiring faulty; Circuit board faulty¸.

E13 - Drain hose incorrectly positioned; Water pressure
insufficient; Water fill solenoid faulty; Leaks or blockage in
pressure switch hydraulic circuit; Pressure switch faulty;
Circuit board faulty.

Dado

Thank you for your post, greg aguilar!
Both error codes "E10" and "E11" stand for fill time is too long on your Frigidaire washer. This could be an issue with the water pressure coming into your washer the psi must be above 30 psi. If it is not you may need to correct the pressure issue. If it is check to assure that the hose is not kinked or blocked. You may need to replace the water inlet valve, pressure sensor, or control panel. I would recommend having a professional technician come out to provide a proper diagnosis for repair. Hope this information is helpful to some degree. -Matt

Hello friend, thanks for your post!
I see that your Electrolux washer is giving off an "E11" error code. An "E11" stands for water is not entering, which can be several possibilities. The water supply to your home has been interrupted or water pressure may be low. Check the hoses to assure they are not kinked and the drain pipe is proper per installation. If these steps have not resolved your issue it could be a problem within the control panel and I would perform a reset on your appliance, which is disconnecting power from it for roughly ten minutes. Hopefully this helps. -Matt

I cannot find what e11 means but it seems most people have just unplugged it an it came back on. Code goes away.

Good Morning Neil, thank you for your post!

Typically, error code E11 indicates that the water fill time is too long. This could be due to a faulty valve, clogged valve filters, kinked inlet hoses, or low water pressure supplied to unit. Also, if the drain hose is installed too deep into the house drain pipe the water may syphon as it fills. At this point, I would recommend having a service technician to diagnose the problem before investing in unnecessary parts.

if its a frigidaire front load washer then code e11 indicates thats its a slow fill water problem,remove your hot and cold inlet water hoses and check the hose screens for blockage

Eb 11 - Invalid unit address / Resettable only at factory / Replace the DCT


Here's a site with a list of fault codes:

How to use Motorola DVR Boot Error Codes

E11 = Long Fill Time
Check to see the water valves are opened all the way. Check water hose screens for buildup.

e11 indicates problem with water supply.Check inlet hoses and water valve