GE Front load washer spinning too slow????

GE Washing Machine GFWS3500L0WW Troubleshooting ...

www.repairclinic.com/...-/GE-Washing-Machine-GFWS3500L0WW-Tr...

GE Washing Machine GFWS3500L0WW ... Washer fills slowly · Washer leaking water · Washer won't start · Washer won't spin or agitate · Washer overflowing ...
Repair Help - Model Help Repairwww.searspartsdirect.com/ge/washer/model-gfws3500l0ww-repair.htmlRepair Symptoms for GE Washer Model #gfws3500l0ww. Shop Parts ... Slow or noagitation or spinning ... Not working at all ... Clean Washer cycle won't work.GE front load washer door latch Repairwww.appliance-repair-it.com/front-load-washer.htmlIf your GE front load washer has a door latch problem such as the door will not lock or... You should always use HE detergent on any front load washer. ... manually unlocking the door and pouring cold water into the tub then start a new cycle.GE Front Load Washer Service modewww.appliance-repair-it.com/GE-front-load-washer.html

Look in the pump and see if maybe something is clogging it. Check the belt.
This video shows how to get into the washer.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

try cleaning the drainage filter located under the front bottom panel.

The bearings have most likely gone bad. This is a very common problem with the front load washer when powder soap is used.

My washer is 1 1/2 years old and I have the same problem.

Just found out that there is a drain trap that can get clogged and needs regular maintenance. Take out the bottom panel by removing 3 phillips screws (7mm nut driver optional). Unscrew the trap (water will probably drain out so be prepared). Clean out debris. You may also have to remove the hose connected into the trap in extreme clogged cases. Just use pliers to release the hose clamp.
Replace the trap plug, hose (if necessary) and the bottom panel.

Good luck!!!

Bryan

Plugged drain hose (which you can easily remove and clean) or slow running household drains.

The drain hose is the approx.2' diameter black hose on the back of the washer that is clamped to the washer and the other end goes into a standpipe or a wall drain. Be sure to turn off your washer and unplug it and have some old towels handy and maybe a bucket!

If there is nothing in the drain pipe, then I would suspect a plug somewhere else in your house that is preventing draining.

Thank you for using Fix Ya and for rating this solution.

front load machines will normaly spin slow on first part of spin cycle this helps distribute load evenly before hi speed spin also if load is extermely off balance ..a large towel with load of light fabrics will never spin to full speed due to off balance produced by wet towel hi speed spin is normaly acheived in last 3-4 min of spin cycle

it sounds like a clogged filter
Please remove the filter on the side of the machine or the front.
Make sure you have towels handy.
Clear the filter out. If your pump cant empty the machine out you will get these problems
Make sure waterline is not obstructed

It is most likely out of balance, could be for many reasons.
1 could be too many heavy items such as jeans, towels, etc in one load.
2 could be the machine or floor is unlevel.
3 Could be a balance sensor needs replacing.