Question about Televison & Video

2 Answers

Tv roll my television has a continous horizontal roll

Posted by on

  • 2 more comments 
  • dehowletts
    dehowletts Feb 07, 2008

    I think i have the same thing but on a KV-36FS76 when TV is turned on there are horizontal lines that travel from top to bottom (sort of roll)

    initially after the TV being on for 10 mins or so they would stop but now they are there constantly...... any suggestions please?

  • jlm1025 Jun 10, 2008

    horizontal hold acting up and cannot find where or how to adjust. I found two screws on back of tv and tried adjusting but to no avail. Any other suggestions?

  • Pattie Steen-Hensley Sep 14, 2008

    tv picture rolls and has no knob or screw to adjust. picture especially rolls when trying to view a tape through vcr
    mg045


  • Joshua Dobbins May 11, 2010

    Need to know the model and brand for any kind of assistance on this one.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Are you sure the roll isnt Vertical? as if it is then all you need to do is adjust the VERTICAL HOLD PRESET POT which should be located on the PCB somewhere, its very unusual for TV.S to roll horizontally as then the picture just goes out of sync. and you would not see a picture at all. When you find the pot turn it ( with a small screw driver) slowly until the rolling stops, if it does not stop then you have a faulty component in the vert. sync. circuitry.

Posted on Feb 06, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 113 Answers

Please close customer not not responding

Posted on Feb 21, 2008


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The horizontal hold


If model number correct (the one posted here) set does not have a horizontal (rolls left to right) or a vertical (rolls top to bottom) control.

Verify model and brand so I may offer some suggestions

Mar 22, 2012 | Mitsubishi VS-5075 50" Rear Projection...

1 Answer

Picture displays horizontal roll


It's the Satellite Disk that is the problem. Just call the guy..

you can also try to unplug and plug it back in.

Oct 23, 2009 | Philips Magnavox 20MS3442 20" TV

1 Answer

No Audio & Video red light blink continously.


hi first of all u should check ur transistor connections.Check your Horizontal and vertical output transistors.You should also check the horizontal and vertical yoke connections as well as your low voltage regulators.... if any of these got damaged u should purchase a new one.. but try to purchase with the help of a tv service assistant...thank u!!!
rate me

May 29, 2009 | Sony KP-57XBR10 57" Rear Projection...

1 Answer

53 Hitachi Ultravison TV : Getting Horizontal lines rolling up


ok
this is called viedo noise
you will need to replace capisitor Cc10 its Value is 1000uf @ 16v the cap is a filter On Sw +9v Line , on pin 20 of Ic01, ( or corma Jungle IC)

Dec 30, 2008 | Hitachi 53UDX10B 53" Rear Projection...

2 Answers

Horizontal roll on mitusbishi 35" tv


is this a horizontal black line going up or down? if yes, this sympton is caused by a trouble in the integrated circuit or in the vertical oscillator circuit. this symptons has 2 variations. one is the intermittent rolling of the picture. this referred to as the "loose vertical hold" the other variations is the continuous upward or downward rolling of the picture

Jan 15, 2007 | Mitsubishi CS-36509 TV

1 Answer

Picture has a horizontal row


this symptom is caused by a trouble in the integrated circuit of in the vertical oscillator circuit. try to look if your tv has a vertical hold control at the back or inside, if it does not have, u have a problem in the vertical oscillator circuit. by the way, its not the horizontal that u should concentrate into, its the vertical. coz this is a vertical sync problem.

Jan 12, 2007 | Konka K2001UM TV

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

352 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

73150 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

yadayada
yadayada

Level 3 Expert

71525 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...