Question about Hoover 24 in. HD97E Free-standing Dishwasher

1 Answer

Error e3 My dishwasher gets halfway through the cycle and then comes up error E3.  It is a hoover hd97e. Please help Fiona

Posted by on

  • Anonymous Feb 03, 2008

    e3 error after a short while hoover dt99

  • Anonymous Mar 10, 2008

    e3 error

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

Drain pump probably not working. Put machine on cycle 7 and it should turn on the drain pump straight away. you can hear this near the bottom of the machine. if it is silent hten the pump probably needs replacing. I repaired mine be removing it and then dismantle the magnet from the tube then give it a good clean out.

Posted on Mar 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My dishwasher is just flashing F10 all the time


Codes are pretty generic between Hotpoint, Hoover and Whirlpool.

Heating element fault
Issue: The LED lights on your dishwasher are displaying in the following sequence (please see below these error codes for your LED reference
  • LED 1: OFF
  • LED 2: ON
  • LED 3: OFF
  • LED 4: ON
Action: We recommend you call our customer service centre to book an engineer.

Here is the Hoover site.
http://service.hoover.co.uk/advice-centre/dishwashers/


Error codes Hotpoint

Jun 19, 2016 | Hoover 24 in. HD97E Free-standing...

2 Answers

My dishwasher gives an E3 error


The E3 error code is not a defined error for this dishwasher. If you are sure it is E3 then best option is to give the controller a reset. This is done by


Press the Delay Start + Normal + Power keys at the same time for two seconds to enter Service Inspection Mode.
- "ALL" is displayed for the first three (3) seconds and then "t1" is displayed.

Press OFF at this stage. Do not attempt to run the inspection as this could damage the dishwasher unless you are familiar with the what each mode does.
If the Error E3 keeps coming back then call the Samsung technician.

Apr 15, 2014 | Samsung DMR57LF Builtin Dishwasher

1 Answer

My washin machine is just stopping thru cycles and beeping continuously until I switch off - reading E3. My father thinks it might be the heater, is that right. I'm having a lot of trouble getting...


Hi, the E3 error is comes up when the water heater element does not work properly or the filter mesh is blocked. Remedy: Clean the filter mesh and if the problem continues, the main board needs to be replaced.

Jun 24, 2011 | Maytag 24 in. MDB6600A Jetclean II...

1 Answer

Dishwasher has been stored for a few months, we have just connected it back up and switched and error code E4 has come up. What does this mean and how to I rectify it?


E4 means that the dishwasher has a problem with discharging water. Check that the discharge tube is not bent and the siphon is not blocked and the filters are not blocked. Depending on how you stored the dishwasher, check for evidence of rodents or insects building nests in the unit.


The manual for the HD97 is available from Hoover at http://service.hoover.co.uk/manuals/Manuals.aspx?Section=3 . Enter the model number and the link will come up. The manual for the free-standing version does not seem to be available separately.

I hope this helps.

Cindy Wells

Jun 12, 2011 | Hoover 24 in. HD97E Free-standing...

1 Answer

I have just bought the above dishwasher 2nd hand


cold water will not clean the dishes/aka break down the detergant

May 31, 2010 | Hoover 24 in. HD97E Free-standing...

1 Answer

Leaking water from door


Hi,
Here is a tip that I wrote about dishwashers and them leaking.

Leaking Dishwasher

heatman101

stuykx

May 19, 2010 | Hoover 24 in. HD97E Free-standing...

2 Answers

Kenwood dishwasher Comes up E3


I do not know the Kenwood dishwasher, hence I do not know what the E3 error is, but many dishwashers require a sustained pressure of at least 30 psi.
Can you please post the model number of your Kenwood dishwasher?

Apr 11, 2009 | Bosch 18 in. SRS45E02 / SRS45E08 Exxcel...

1 Answer

Halfway through the cycle it beeps an E3 code and stops running?


make sure the faucet is on. if it's turned off you will receive the error (err03) code.

Dec 04, 2008 | Danby 22 in. DDW396 Free-standing...

Not finding what you are looking for?
Hoover 24 in. HD97E Free-standing Dishwasher Logo

Related Topics:

729 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hoover Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Cindy Wells

Level 3 Expert

5524 Answers

Jose Pino

Level 3 Expert

563 Answers

Are you a Hoover Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...