Hi,i have a akai 42 in rear projection tv about 3 years old.i cut it off on christmas eve and the next day it woulf not cut on with the remote or power button on the front.the red light comes on ,but there is no power,thanks joe
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi, Red light blinking 3 times shows problem with lamp cover. Lamp cover is not fixed securely in your tv after lamp replacement. Lamp cover is first thing that was removed to replace lamp, check lamp cover and make sure its back in place properly. Thanks.
hi, the input blocks are where you will need to look for this problem. sometimes these block connection become lose and detached from the main logic board. this could happen due to a minor crack in the solder or to much pressure when inserting cables and input rac jacks etc.. replacing or repairing this section of your TV's board will fix this issue.
If the convergence is very far off the convergence ICs are bad and need to be replaced first. If the convergence is close and it wont correct it might just be an insect or some dust on the sensors at the 12, 3, 6 and 9 o'clock posistions behind the screen.
Hear say has it that Toshiba who made alot of the internal parts for this model can offer more help than Akai.
As for the other problems... first Id try leaving the TV unplugged for a day or so. This is a great TV, picked mine up for 400 from my boss who baught it a few years back for 1400 from Sams Club. If I hear a solution I'll be sure to come back here and post it.