Question about Sharp AR-M450N Copier
On the copier press #, *, Clear, * quickly. The machine will say Enter Simulation. Press 16, Start, Start. The machine will reboot and should be fine. If it reoccurs you'll need a new PCU pwb
Posted on Jan 29, 2008
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You're getting a heat roller low temp detection on the fuser in your copier. The fuser is the device that provides heat and pressure to the toner to bond/fuse it to the paper (it's that black, rectangular box in the upper part of the body when you open the left-hand side of the door).
Chances are a peice of paper is jammed up inside and blocking the sensor (probably a small peice that tore from a page someone tried to pull from the fuser). That or the temp sensor is defective.
Posted on Aug 21, 2009
Tips for a great answer:
Hello Roger, thank you for your inquiry!
Based off the information you have provided you would like to know what an E-11 error code means on your Frigidaire washer. An E-11 error code means that the fill time is too long. This could be a possible problem with your pressure sensor, water valve, or main control panel. If the water pressure is below 30 PSI then it will continue to display the error code of E-11. Also make sure the hoses are not restricted or blocked because this could cause the error code to display. I hope this information has been helpful to you. -Matt
Dec 01, 2015 | Frigidaire Affinity ATF6000F Front Load...
Jun 06, 2014 | EuroTech 24 in. EDW154E Built-in...
Feb 22, 2013 | Sharp AR-M450N Copier
Jan 24, 2013 | Sharp Office Equipment & Supplies
May 11, 2012 | Samsung Washing Machines
Thank you for contacting Fixya.com.
The "E1" error code means the thermistor is open but it could be also a broken wire, loose connections at the teamster and/or the control board and a bad control board.
Please get back to us if you have any further query.
Have a nice day.
Dec 02, 2010 | Kenmore Dryers
Aug 10, 2010 | Nintendo Wii Console
370 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: