Question about Recoton Advent Advent AW-871 Main / Stereo Speaker

1 Answer

My tv turns on and then shuts off after 10 seconds . i recently had power surge and the tv was plugged but off . what could be wrong?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 54 Answers

Sir?? i think the power supply of ur tv is defective???kindly check it out the power supply section,,,thnkzz and hope too help you!!

Posted on Jan 29, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I turn on my Sony TV, ti stays on about 30 seconds then shuts off, What do you think is wrong?


Do a Power Reset.
1. Turn off TV.
2. Unplug the power cord of the TV from the electrical outlet.
3. Let the TV remain without power for 60 seconds.
4. Plug the power cord back into the electrical outlet. (If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.)
5. Turn on the TV.
If issue persists after doing the steps, reset the TV to factory default settings.
1. Turn on the TV.
2. Using the supplied remote, press and hold the UP arrow button.
3. While holding the UP arrow button press the POWER button on the TV itself.
4. When the TV goes off, release the POWER and UP arrow button.
5. The TV will turn on by itself and the initial setup screen will be displayed. Just follow the on-screen prompts to finish the setup.
Sony KDL 46V5100 random shut off 15 20 sec

Feb 25, 2016 | Sony Televison & Video

1 Answer

NO POWER


Need to know how many times the led is blinking.

Try this link for more informationmessage_type_solution.png

Re: tv kdl-55ex620 red light blink 8 times Do a Power Reset. 1. While the TV is off, unplug the power cord of the TV from the electrical outlet. 2. Let the TV remain without power for 60 seconds. 3. Plug the power cord back into the electrical outlet. (If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.) 4. Turn on the TV. 5. When the TV powers on and a picture is displayed, reset the TV to factory default settings.
  • If the Reset message does not appear and the TV turns off and on, begin again from step 5.
  • If the standby light begins blinking eight times, return to step 1.
6. After the Reset message appears, allow the TV to reset. Do not press any buttons on the remote control or on the TV and do not make any other adjustments for 1 minute. 7. Unplug the power cord from the electrical outlet. 8. Allow the TV to remain without power for 10 seconds. 9. Plug the power cord back into the electrical outlet. 10. Turn on the TV.
  • The initial setup screen displays if the above procedures were performed correctly.
11. Follow the on-screen instructions to complete the initial set up. 12. Perform a system software (firmware) update.

Sep 04, 2012 | Sony KDL55EX620 55 inch BRAVIA 1080p LED...

1 Answer

Color recently changed and I cannot get it adjusted properly. Picture goes in and out.


Please do the following steps:

  1. Turn on the television.
  2. Please wait approximately 40 seconds for your TV to completely start up.
  3. On the TV remote control, press and hold the UP ARROW button.
  4. While holding the UP ARROW button, press and release the POWER button on the TV set. (The button may be on the front, top or side of the TV.) NOTE: The TV may turn off and then back on.
  5. Release the UP ARROW button.
If the issue does not resolve, please follow these steps:

  1. Turn off the television. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.
  2. Unplug the television power cord from the electrical outlet.
  3. Let the television remain without power for 60 seconds.
  4. Plug the power cord back into the electrical outlet. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
  5. Turn on the television.

Feb 27, 2011 | Sony FD Trinitron WEGA KV-36FS120 36" TV

1 Answer

I have 20MC4306. Recently when you turn it off it turns itself back on. Also when you turn it on shuts off after 2 seconds. Tried putting in a video vhs then press play and wait few seconds and hit...


Sometimes when the TV recives a brodcast signal for a new update to the mainframes firmware, it will have to turn itself on to install/recive the update and aslong as it is connected to a power source it can do this. hope this helped answer your question. Have a good day :)

Jan 03, 2011 | Philips Magnavox 20MC4306 20" TV/VCR/DVD

1 Answer

When i power up the tv, it immediately shuts off


How old is the tv? Sounds like the bulb. Is there any kind of lamp light indicator blinking or on? Averager life of a bulb is a few years, but could very well be shortened. Also check any surge protectors you might have. Maybe you recently had a surge and it needs to be reset. Last but not least try recycling the power on the tv. Unplug for 10 seconds then plug back in. happens a lot with cable boxes, recievers, and tv's from time to time.

Mar 17, 2009 | Mitsubishi WS-65807 65" Rear Projection...

1 Answer

TV won't turn on


I am having problems turning on the tv. I had lost the remote control so I bought a universal remote which was not working at the time I unpluged the tv form the powersocket then I tryed to turn on the tv the green power light stays on for a few seconds then it blinks two times then there isn't a power light on after that what is wrong

Jul 26, 2007 | Mitsubishi WS-48613 48" Rear Projection...

1 Answer

Tv shuts off after5 seconds


I,m sorry if not help you, but some those combo system when the Vcr have problem or stuck it shuts down, then you have to fix the Vcr frist. zcheck if the Vcr is ok. Aleixo

Aug 29, 2006 | eVision EC720E 20 in. TV/VCR/DVD Combo

Not finding what you are looking for?
Recoton Advent Advent AW-871 Main / Stereo Speaker Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Recoton Advent Audio Players & Recorders Experts

Ron Rak
Ron Rak

Level 1 Expert

47 Answers

NOEL
NOEL

Level 3 Expert

8374 Answers

Tom Chichester

Level 3 Expert

44896 Answers

Are you a Recoton Advent Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...