Question about Washing Machines

1 Answer

Asko 6431 washing machine

Hi, my washing machinestops 10 seconds into any cycle and comes up with the message 'F2' - what does this mean - I have not been able to find a local repair man who deals with this brand (Newcastle Australia).


Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 126 Answers
Re: Asko 6431 washing machine

Check inlethose, and the filter in the valve.

Posted on Jan 28, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Machine has no power

check the lid switch they come loose and will shut the machine off!, open lid, hold switch closed position with screwdriver or something

Feb 02, 2015 | Washing Machines

1 Answer

HI our 10 year old front loading machine has stopped through a cycle and we cant get it spinning or pumping and cant open door to get out washing. Any advice? Thankyou Keith


Welcome to FixYa.

There is typically a drain filter in the pump as well as a door lock release on Asko built machines, but I'd need a model number to be specific to your machine.

This is the typical procedure for machines of the past 10yrs. or so...

Hopefully this will help. if yours is different I'll have to wait for your reply with a model number before we can proceed.


Macmarkus :)

Jan 09, 2011 | Asko Washing Machines

1 Answer

Cannot stop cycle once it has been started and temp is too high

See manual for reset - HOLD stop-button for more then 5 seconds, thats solves the problem :-)

May 22, 2009 | Asko Washing Machines

1 Answer

ASKO washer WL6511XXLPP

Purchased ASKO Washer WL6511XXLP and Gas Dryer with pedestals, 12/01/09. It threw a drum paddle during 2nd. wash cycle. Damaged several articles of clothing.
ASKO replaced the paddle 2/19/09 after a lot of phone calls (lip service from the ASKO 800 #). They claimed the part had to come from Sweden (reason for delay).
Washer threw another drum paddle during 4th. wash cycle. Damaged several more articles of clothing. We have made no claim for the damaged clothing, the retailer has been cooperative.

ASKO has promised to replace the washer after the retailer we purchased the washer from, strongly encouraged them to do so. We are still without a washer (03/23/09). My wife and I are retired, I am 76. Point being; we do not abuse washing machines and we don't like going to a launder-mat.
I know this is not the venue to address this problem, but am at my wits end.

Mar 22, 2009 | Asko WL6511W Front Load Washer

1 Answer

Wsher stops in the rinse cycle wiht a n F4 message

f2 error means long drain or no drain
check the drain pump
replace drain pump if nessesary

Mar 17, 2009 | Kenmore Washing Machines

1 Answer

Asko 10505 runs through was cycle in approx. 30 seconds, then wont drain. Simply stops. It doesnt matter which cycle I start with, the dial moves quickly to stop. It fill with water and spins. ANY HELP...

hi sir' start the wash machine empty and see if it happens when nothing is in it.
2. When machine is off, open the top grab the centerpiece inside the wash machine and pull and push it slowly, does it move? (For safety unplug the machine)
3. Make sure machine is 100% level (front to back, left to right)

The most common thing is bad drum bearing, which force the wash machine out of whack when in spin / wash. Which are common and the best thing is to call Maytag. 

thank u .........................................please rate


Sep 11, 2008 | Asko Washing Machines

1 Answer

I have a hotpoint aquarius wf645 when i put it on a wash cycle it will fill for 1 minute then drain a message comes up F-o7 please help

hold in the start and cancel buttons for 10 seconds, a "test on" message appears, hold in the start and cancel button again for 10 seconds and "test off" message appears, set your wash to whatever mode and it should did for me!

Apr 26, 2008 | Hotpoint Washing Machines

2 Answers

Asko Excellence Dishwasher Model # 1504

I have a manual for 1504 and it says F2 blinking means high water level in machine

Apr 15, 2008 | Asko W6021 Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides