Mitsubishi WS 55413. Ongoing rolling screen.

Hi this is the user manual for ur Tv , Hope that can Help u , Good Luck
http://www.audiolabga.com/pdf/WS55315.pdf

Yes. It will.

Have the remote tested alone--all shops can do this and if it tests good suspect the remote receiver in the set (usually is dead center behind the screen in the middle above the lens.

You may kneed a new lamp try Discount Merchant they also trouble shoot

800-553-7278 CALL MITSUBISHI PARTS
A WS-55413 LENTICULAR SCREEN IS $171.10 + DELIVERY BUT THE DIAMOND SHIELD ISNT NEEDED THEY TELL ME AND IT WAS DISCONTINUED ANYWAYS BUT YOUR PART IS PROBABLY AVAILABLE THERE.

There is no "reset" as the set has in the customer and tech menus ways to attempt to manually adjust this.

under convergence in the customer menu select advanced and follow the instructions on the screen.


If Red or Blue or Green are skewed and will not adjust it means one of the two STK-394-250 CONVERGENCE chips this set uses is bad.

Depending on where you buy them they will range in price from about 12 dollars each to nearly 35 dollars each.

Let me know what you find; this may or may not be a do it yourself repair as some real expertise is required to correctly get at and replace the chips.

SD TECH

was to little info .... is it on all inputs, if you turn up the sound all teh way do you hear hissing from the speakers....

have you reset you cable box i go out on at less one call a mounth that no sound is the cable box

Howdy,
The control buttons may be getting stuck. Try this:
1. Remove front speaker grill
2. Disconnect the two cables that are sticking out of the top of the inner cover. The TV will still work with remote. If that helps replace switches, control board not available. Part Number 432P109010 quanity 9.

Hope this helps, big IRISH.

you have some caps that have failed in the dm module
that will have to be replaced to correct the problem
if your know how to change them and have the tools the caps can be obtained through most electroinc parts suppliers
there 1000mfd 16v we increase working voltage to 35WV
if you can change them let me know and i can give you locations on the board and the dm stands on the right side of chassis at rear

you may have a convergence problum if your convergence ic,s are shorted, you will need to check the convergence fuses in the power supply.