Question about Panasonic KX TGA270S Cordless Expansion Handset

3 Answers

How do I add an extension handset to my current config?

I have the kx-tga270s phone system and i wanted to add another handset. I fully charged the battery but get "no link to base...." message. what do I do next?
Thanks,
Liz

Posted by on

  • elizagilbert Nov 23, 2008

    I have the same problem but from what I have seen from the solution is to press "menu" on the hand set. There is no "menu" button. I then found a manual for this phone. It said to press the mute button on the base and then the 3rd soft button on the handset to press for "ok". This did not work either. Any suggestions are greatly appreciated

×

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

IF it was a used handset it was likely registered to another base. I just switched bases (1line to a 2 line base). I had to "deregister" the handsets from the old base. I am not sure if you can deregister if the old base is not present? With the old base plugged into power I hit the "function key" at the bottom left of the handset and scrolled down to initial settings. Under registration is "deregistration". I selected that and it put the handset back to its default out of the box. Then simply hit the mute button on the New base and OK on the handset. Worked for all 5 of my old handsets.

Hope this helps

Posted on Feb 23, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If you have a Kx-tga270 phone that is registered to a base you do not have you can still register it to a new base by pressing and holding the mute button until the light flashes, the on the handset go to menu and go to inital settings register and press OK

Posted on Nov 19, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

PUT NEW PHONE ON BASE; PRESS MENU; PRESS ZERO (0) TWO TIMES; # # # ENTER A NUMBER YOU WANT ASSIGNED TO THAT NUMBER; CHARGING LIGHT SHOULD COME ON; ON YOUR EXTENSION PHONE SITTING ON THE BASE WILL HAVE AN OK COME UP IN THE BOTTOM RIGHT HAND CORNER OF THE DISPLAY. PRESS OK. HOPEFULLY YOU WILL GET ON LINE. PAGE 46 OF MY HANDBOOK FOR REGISTERING A PHONE. . TO REGISTER YOUR FIRST EXTENSION HIT 0-0 ; PRESS AND HOLD "INTERCOM" UNTIL THE CHARGE LIGHT STARTS FLASHING; THE PRESS THE OK BUTTON THAT SHOULD COME ON YOUR DISPLAY.

Posted on Jan 28, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ringer


There is a section on setting the number of rings in the manual for the base unit on page 28. You can download it from here: http://www2.panasonic.com/consumer-electronics/support/Phones-Fax/Telephones/Expandable-Systems/model.KX-TG2740S

c:\documents and settings\bruce\application data\pixelmetrics\capturewiz\lastcaptures\2010-04-21_15-45-33-014.pngc:\documents and settings\bruce\application data\pixelmetrics\capturewiz\lastcaptures\2010-04-21_15-45-33-014.png

Apr 21, 2010 | Panasonic KX TGA270S Cordless Expansion...

1 Answer

Need to clear out a used kx-tga270s handset


press function, initial setting, registration, deregistration, enter 335(deL) and then press Ok (right button on screen).
Once that is done press mute on the base unit and Ok on the hanset (right button on sreen)

Mar 28, 2009 | Panasonic KX TGA270S Cordless Expansion...

1 Answer

TOO FAR FROM BASE


Hi! This may cure your problem!
Re-registering the handset
If “No link to base. Move closer
to base, try again.
” is displayed
even when the handset is near the base
unit, you may need to re-register the
handset to the base unit.
Important:
LMake sure the base unit is not being
used.
LHave the handset and base unit near
each other when re-registering the
handset.
LKX-TG5422 and KX-TG5423 only:
Confirm the extension number of the
handset which has lost its link to the
base by placing the handset on the base
unit or charger.
If you accidentally assign another
handset’s extension number to it, the
other extension will stop functioning.
1 Handset:
Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Registration” by pressing
{V} or {^}, then press {>}.
4 KX-TG5421 base unit:
Press and hold {HANDSET
LOCATOR
} until the CHARGE
indicator flashes.
KX-TG5422 base unit:
Press and hold the handset locator
button that corresponds to the handset
you want to re-register ({HANDSET
LOCATOR
1} or {HANDSET
LOCATOR
2}) until the CHARGE
indicator flashes.

Below is a link that will take you to the instruction manual for your phone.

http://www.phone-manuals.com/panasonic/KX-TG5422M.shtml

Hope this helps! Hal

Feb 27, 2009 | Panasonic KX-TG5422M Cordless Phone

1 Answer

Hanset ringer off line


Hi - You can download the manual from the link below:

kx-tga270s

cbbc339.jpg

Please update the question & let us know if the information given was useful to you - Good Luck!

Jul 05, 2008 | Panasonic KX TGA270S Cordless Expansion...

5 Answers

Carnt change the time on my phone


For Panasonic system (especially for KX-T7633), you have to make changes from extension 101.
1. leave handset in the cradle then press "program".
2. Dial *# then "SP-PHONE" button until you see something like time set something something
3. manually input correct date then time then press "auto dial/store" button.
4. pick up the handset then hang up to save.

Mar 30, 2008 | Panasonic KX-T7633 Corded Phone

1 Answer

How do you get the KX-TGA270S apart to replace the Antenna


Real easy... remove the battery and you'll see 2 screws. then start peeling the phone in half from where the screws were.. the phone may seem like its breaking but it does snap apart... then you will needs a soldering iron to replace the antenna..

Nov 13, 2007 | Panasonic KX TGA270S Cordless Expansion...

Not finding what you are looking for?
Panasonic KX TGA270S Cordless Expansion Handset Logo

766 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Lands Phones Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

guyvstewart

Level 2 Expert

85 Answers

john milligan

Level 3 Expert

514 Answers

Are you a Panasonic Lands Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...