Water not wringing out

Washing Machine Won't Wring Out Clothes Properly - DIY ...

www.diychatroom.com/.../washing-machine-wont-wring-out-clothes-pro...
Apr 16, 2013 - 6 posts - ‎4 authors ... thing - the spin cycle doesn't really seem to do an effective job of wringing out theclothes once. ... Sounds like it's not spinning fast enough.

Washer does not wring out the clothes. Clothes are dripping ...

Could be that the spin cycle is not rotating at the required speed to wring out your clothes. Check that the cycle completes at a significant speed to generate centripetal acceleration forcing out the water. Perhaps the load is unbalanced which can trigger the spinning cycle to repeatedly stop during the spin cycle.

Sounds like the clutch may be slipping. Does it go into a high speed spin?

Sounds like the timer is screwed... Sending out the wrong signals and the dryer is doing the rinse cycle when it should just be the spin cycle. Do t know what your timer looks like in that washer but most now days look like the picture.

Don't pause the cycle mid cycle. The machine uses the amount of water it needs to clean the amount of clothes that are in the tub. If you pause it after the first 7 or 8 minutes, you're already past the sensing part of the cycle and likely you won't get more water for the additional clothes.

Also, the clothes don't need to be soaking wet or wet enough to wring out. These new HE machines mix the detergent with water and then spray that detergent solution onto your clothes. Then the clothes against clothes rubbing with that solution already coating the clothes is how the machines clean better! It is a very similar process to when you pretreat your clothes with Shout of Spray and Wash. You spray the clothes and then rub the short against itself. Now the Whirlpool machines are doing this for you!

if all of the water does not drain could be the water pump or if the washer does not spin fast enough to wring the clothes could be a worn out motor or tansmission

Interesting... I don't have a solution, just a related problem. Belt broke and after repair, I observed that water is leaking from the bottom of the tub during wash cycle. I guess it could be a cracked tub (not too likely) or a gasket around the agitator bearing. I'd like some advice on this as well.... and how to get to it. The drive belt was a pain....

check drain hose kink or belt adjustment...worn clutch...basket drive

It sounds like you need a water pump!
See if it's pumping water next time you do load by looking at the discharge hose going to the drainage pipe and get back to me!
jack

bad motor most likely. easy fix

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61