Question about Maytag LSE7806A Top Load Stacked Washer/Dryer

1 Answer

Maytag stackable w/d

No power to washer, is there an internal fuse inside the washer?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 2 Answers
Re: maytag stackable w/d

Yes, it is inside the front washer lower front panel. Turn off poawer to unit and change w/ 1Amp 250V (regular of slow-blow). Then try only opening washer lid door with full dial pushed in (that would be the 'off' position. Only open/close lid w/ dial in off position. If washer works normally, may have a temp solution. Mine started this way, but ultimately the double relayed door lid switch was going bad and I had to replace it. Instructions/pictures below. Good Luck


Posted on Feb 01, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Maytag lse7804ade

Buy the right size fuse. Too big of a fuse can cause a fire.

Aug 23, 2014 | Maytag Washing Machines

1 Answer

Maytag neptune model mhs2000aww stackable dyer works but washer side not getting power why

test this steps and fix it. God bless you

  • No power to the washerMake sure there's power getting to the washer. Check for a tripped circuit breaker or a blown fuse. Check the wall socket for power. Sometimes the power cord disconnects at the washer, if this is the case, the wiring must be repaired or replaced.
  • Lid switchThe washing machine may not function if the lid switch is defective. The switch is usually located near the door. Replace if found defectiv

  • Read more:

    Oct 01, 2013 | Maytag Neptune Washing Machines

    1 Answer

    I have a stackable Maytag. The water will not

    I had a similar problem I just fixed. There is a fuse inside that keeps the water from filling if it's blown. Might try changing that first.

    Jul 19, 2009 | Maytag LSE7806A Top Load Stacked...

    1 Answer

    Washer does nothing when you pull the button to start

    It is probably the lid switch. On some machines there is a lid switch fuse that may not be in your wiring diagram for your machine.

    Some of the fuses are glass and look like an automotive fuse and there are some enclosed in the switch assembly that you can't see unless you drill out the rivets holding the switch together.

    It is a carbon fuse with a spring on each end pulling on it.

    I had the same problem with mine and Maytag tech told me there was not a fuse in the switch.

    This made troubleshooting especially frustrating.

    Apr 15, 2009 | Maytag Performa PAV3200

    1 Answer

    Matag stackable My Drier Squeals loud on start up

    could be motor put oil on back baring aka rollers

    Jan 29, 2009 | Maytag LSE7806A Top Load Stacked...

    1 Answer

    Maytag stackable washer top loader

    try replacing entire lid switch assy, come ith new fuse!

    Oct 31, 2008 | LG WM2077CW Laundry XL Front Load...

    1 Answer

    I have a maytag stackable washer dryer model number LSE7800ACW when i turn on the washer it will not fill it will not spin it will not do anything but the dryer works just fine. What is wrong

    HI. thanks for the question. you have a blown fuse ,inside the washer. remove the front panel. on the left ,you will find a small glass fuse .check that. if its failed you will be able to see, that the small metal strip inside the fuse is broken , if so replace the fuse. thanks the appliance doc . please rate my answer.

    Oct 07, 2008 | Maytag Washing Machines

    1 Answer

    Storage of Maytag Neputune stackable unit

    Just put inside a big cartoon or a box crete, just to preserve,the paint and the machine ...

    hope this nay help;

    Aug 21, 2008 | Maytag Neptune MAH5500B Front Load Washer

    1 Answer

    No Power

    go to your fuse box if 220 flip both switches if fuse engaged there will be like a red line or fully difused down to show that fuses has been triped
    if 110 your going to be flipping switches alot cause 110 runs both motor and guages together and over power is usually the cause of this
    220 circuit one 110 runs the guages and the other 110 runs the motor and heater core
    also washer wont run with out the water being on saftey feature

    Nov 12, 2007 | Maytag LSE7806A Top Load Stacked...

    1 Answer

    Maytag Neptune Stackable washer continues to fill with water when unit is off

    If the machine continues to fill even after the power has been switched off, this sounds like a stuck inlet valve. To identify the valve, look at your model in the "parts store" section of Maytag's website. The valve is item 21 on the "Control Panel, Top & Lid" drawing. From the drawing, the valve looks like a fairly standard item; I suspect you might get something suitable a bit cheaper elsewhere. A

    Feb 05, 2007 | Maytag Neptune FAV6800AW Top Load Washer

    Not finding what you are looking for?
    Maytag LSE7806A Top Load Stacked Washer/Dryer Logo

    266 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Maytag Washing Machines Experts

    Richard Roth
    Richard Roth

    Level 3 Expert

    9472 Answers

    Al Clark

    Level 2 Expert

    290 Answers

    Todd Marr
    Todd Marr

    Level 2 Expert

    77 Answers

    Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides