Problems with my print server. Just stopped working yesterday day out of the blew. No getting following error: Network host '192.168.1.2' is busy; will retry in 15 seconds...

QuickBooks has made it easier for everybody to access the company file from the server or host system. But, if somehow you come across the error QuickBooks hosting mode is off, then the scenario will become entirely different and complicated for you. Therefore, there are some requirements that you must follow if you do not want yourself to stick in the same situation:


1. You must save your QuickBooks Company file in a shared folder.
2. Your system must be set for the multi-user mode.
3. As a user, you need to map the server or the host system as the network drive for each and individual workstation.

If any query regarding the resolution of QuickBooks hosting mode is off persists, feel-free to get in touch with our experts.

take the printer server host name and goto start run and put the \\hostname it will open the all shared items and right click on the printer and select connect it will install the printer............... or else you have to give a spacified IP address to the printer server.............

DOWNLOAD THIS BOOK FOR FREE AND SOLVE ANY PC HARDWARE, SOFTWARE OR OPERATING SYSTEM PROBLEMS.




DOWNLOAD NOW......

Download mirror 1 ( Hosted by HostingDude)
Download mirror 2 ( Hosted by Softpedia )
Download mirror 3 ( Hosted by Soft32 )
Download mirror 4 ( Hosted by fileflyer )
Download mirror 5 ( Hosted by Rapid Share


369

Make sure the status and configuration of the print server. Check following:

1 Make sure that the machine is powered on, is on-line and ready to print.

2 Print the Network Configuration List of the machine and check if the settings such as IP address settings
are correct for your network. The problem may be the result of mismatched or duplicate IP address.
Verify that the IP address is correctly loaded into the print server. And make sure that no other nodes on
the network have this IP address.

3 Verify that the print server is on your network as follows:
For Windows®
(1) Try pinging the print server from the host operating system command prompt with the command:
ping ipaddress
Where ipaddress is the print server IP address (note that in some instances it can take up to two
minutes for the print server to load its IP address after setting the IP address).
(2) If a successful response is received, then proceed to Windows® 98/98SE/Me Peer-to-Peer print
(LPR) troubleshooting. Otherwise, proceed to Step 4.

4 Reset the print server back to the default factory settings and try from the initial setup again. For
information how to reset to the default factory settings, see Restoring the network settings to factory in the manual.

I found a solution that worked for me by prowling around various Apple discussion forums. The two keys to the solution for me were numbers 3 and 5 below.

1. Opened print/fax preferences
2. Opened Add printer by clicking the +
3. For protocol, select HP jetdirect-socket (not IPP or LDP)
4. Determined the IP address for my Belkin wired print server and typed this into the Address line of printer setup
5. Manually selected the printer driver as ML-2010. It is in the list of drivers but is in the M's, not under the Samsung drivers.
6. This worked for me. I've seen reports from people who had to power cycle their print server and/or printer as well.