Set covection baking temp / Thermador MCES

Here is a link to specs and the installation manual. It may suggest how to get it out. Also, another link has text related to removal. I notice one video suggesting this could be a very physical endeavor. And some suggest getting a convection oven rather than another microwave. I have no opinion on that. It is not hard to guess that precise measurements are a must in this quest.

https://www.thermador.com/us/supportdetail/product/MCES/01

https://www.houzz.com/discussions/4980768/how-to-remove-thermador-mces-built-in-microwave-trim

Perhaps the high voltage diode is the culprit.

Test info here: How to Test The High Voltage Diode Rectifier Used In Microwave Ovens

An important additinal test not mentined there is shown in the attached picture.

For more free help, feel free to contact me via my site with your detailed symptoms and full model number and FCC ID number as shown on the tag in or on the oven.

If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/

The oven temperature may be too high. Get an oven thermometer and set it in the center of your oven and check to see if the temperature on your oven matches it. Many ovens run 25 degrees or more off of the set temperature. My mother's oven used to need to be set at 325 if she wanted it to bake at 350.


If the cookies are black on the bottom, but doughy in the centers, this may also be a case where the oven temperature is too high.
Another problem may be that you are baking them too long. Cookie baking is a precise thing. It may seem duh-obvious, but be sure you use a timer, lol. If the recipe calls for 10 minutes, and they are always burned, start checking them at 8 minutes.

If you are substituting honey for the sugar in the recipe, remember to lower the oven temperature by 25 degrees and decrease the liquids by a small amount to compensate. Honey browns/burns much faster than sugar.

Hope these suggestions help. =)

unplug the appliance from the main socket and plug it after sometime

It may need a reset. You can do that by unplugging the power for a minute or two, then plugging it back in and setting the clock.

If it still fails, you may have a failing cooling fan or a problem on the control circuit board.

magnetron short defect. change magnetron

The microprocessor has been scrambled due to power surge when it came back on. There is only possible thing you can try, unplug the oven for 30 minutes and plug it back in, this might reset the ic, if not you will need appliance repairman to assess the situation.

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Basic Microwave Oven TroubleshootingTips

heatman101/'/'

I would check GE's website, they probably have a forum where you could get a better answer.