Question about ASUS Terminator 2 Barebone

3 Answers

I JUST STARTED THE SET UP ON MY NEW PRINTER C5180 PHOTOSMART SERIES, I FOLLOWED THE SET UP DIRECTIONS, I AM UP TO STEP 11 CLOSE THE ACESS DOOR AND PRESS OK AND NOTHING HAPPENS, IT IS SUPPOSED TO PRINT AN ALIGN SHEET, IT DOESENT OR SOUND LIKE THE PRINTER HEAD IS MOVING, I TRIED TO PRESS OK AGAIN AND NOTHING

Posted by on

Ad

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 126 Answers

Please remove the drivers and software that came with the printer go to controll panel and in add remove programs remove any new printer programs that were installed and then go to add remove hardware then remove printer from there if not possible go to device manager and remove printer. after removal of these items unplug printer and reboot computer . wait till completly loaded then plug in printer to the required usb port then wait till windows xp loads all software drivers for printer once it does it will prompt you through the rest of the installation xp will bring up the printer fax wizard next do what wizard says after printer is recognized then do a test print page and you should be ready to go but plz remember to remove printer from device manager before turn on printer or before pluging in printer ok good luck with it and be patient

Posted on Jul 01, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Try going to control panel/administrative tools/services..

u should find a sentence in there saying PRINT SPOOLER..
right click it and click STOP.. w8 about 30 sec. thet right click it and click start.. .. or.. maybe.. coz its brand new.. some HPs will set their heads for about 45mins. ...

Posted on May 07, 2008

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,985 Answers

Please not type in capitals - this seen as shouting - don't do it again.
-------------------------------------------------------------------------------------------------

now please give more information on the computer you are using
The make and the operating system

Posted on Jan 25, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Printer HP Photosmart C5180 Series cannot be contacted over the network


Check with HP for a Windows 7 driver for the printer. HP Ink Jets require proper drivers to work correctly. Once you have downloaded and installed the drivers try connecting again.
If you have installed the drivers and Windows 7 still refuses to "talk" to the printer, you may have to adjust your advanced network settings as well. Open up the Network and Sharing center, click on advanced sharing settings and make sure file and printer sharing is turned on. Also check "File Sharing Connections" and enable file sharing for devices that use 40 or 56 bit encryption.
If that fails to work you may need to speak with HP support for further assistance.

Feb 23, 2012 | HP Photosmart C5180 All-In-One InkJet...

1 Answer

How to connect HP photosmart c5180 printer


go to hp support It will ask what model printer you have plug in c5180. Download full software package for your os. Save to desktop and then run. Just follow directions and should connect fine.

May 03, 2011 | HP Photosmart C5180 All-In-One InkJet...

2 Answers

I have an problem on my printer hp photosmart c5180 all-in-one printer report eror 0xc190027 thank you


To solve the error code 0xc19a0021. There is following solution.
Follow it step by step

  • Reset the printer without turning off the printer, disconnect the USB cable from the rear of the printer
  • Remove the cartridges from the printer
  • Wait for the 'Insert Cartridges' message to display on the control panel
  • Disconnect the power from the back of the printer
  • Now wait 60 seconds
  • Now reconnect the power If the product does not automatically turn on, press the Power button
  • Reinsert the cartridges, and then close any open doors on the printer.
  • If you receive a prompt to print a calibration page.Print it
  • Reconnect the USB cable to the port of the printer & then try printing again
By this error will automatically remove. But if u face still this error then printer service required

I hope this solution will helpful 4 u
Please don't forget to click on Four thumbs which are given below & then write testimonial in your words for appreciation if it is helpful
THANKS & Keep Using fixya

Mar 27, 2011 | HP Photosmart C5180 All-In-One InkJet...

1 Answer

Failure Oxc19ac001 i tried the options but its doesn't work


Hi Please follow the the steps given below Make sure that the printer's power cord is connected to the walljack (Avoid if there is any surge protector or extension cord) Take out all the ink cartridges Take a clean cloth, dampen it in distilled water and with that cloth clean copper contacts of the cartridges firmly Let them dry for 2 minutes Unplug all the cables from the back of the printer while printer is turned on (After closing all the doors that are open and also keep the cartridges out) After 2 minutes, plug in the power cable Put the ink cartridges in one by one, then close all the doors again Printer would start going through some maintence and then would start aligning the ink cartridges All the best!! Regards

Oct 28, 2010 | HP Photosmart C5180 All-In-One InkJet...

2 Answers

My HP Photosmart C5180 printer keeps coming up with an error message 'Ink System Failure. Does anybody know what is needed to solve the problem.


Hello,

The "Ink System Failure" error is causes by air in the ink feed tubes. We have a step by step guide purging the air from the feed tubes posted on our web site. Go to our site at: www.ccl-la.com, click on the printer repair link and then the HP link. Follow the steps and you should be back printing in no time at all.

I hope this helps, If so please rate our solution.

Buddy
Corporate Computer
www.ccl-la.com

Nov 01, 2009 | HP Photosmart C5180 All-In-One InkJet...

1 Answer

I have a HP Photosmart C5180 printer and am trying to install it on my PC. I have the disc that says HP Photosmart C5100 series for Windows 2000, XP I get so far into the install and it tells me my print...


Hi,

please perform the steps below and then try to install the software:

1. Click Start , select Settings , and then click Control Panel .
2. Double-click Administrative Tools .
3. Double-click Services .
4. Right-click Print Spooler and select Stop to stop the services.
5. Click Restart to restart the service.
6. Click OK .
7. Restart the computer.

Oct 03, 2009 | HP Photosmart C5180 All-In-One InkJet...

1 Answer

HP photosmart c5180 will not sense new yellow cartridge have tryed different cartridges


you could perform a reset by removing all the cartrdiges on the printer. and also try with cleanning the cartrdige contact iside the printer
to reset the printer follow below steps
1. Unplug the power cable from printer when the printer is powered on.

2. Press and hold OK and HELP buttons while plugging in the power cord.

Oct 02, 2009 | HP Photosmart C5180 All-In-One InkJet...

1 Answer

HP photosmart c5180 with vista 32 operating system, scanner on HP will not work with Vista os and HP instructions to go to Paint will not work either


you could be having application error. since you can print, you should be able to scan.
uninstall the entire package and start afresh, but follow the steps critically.

Aug 21, 2009 | HP Photosmart C5180 All-In-One InkJet...

2 Answers

Printer will not print


Printer shows error code Ovc 19a0024

Jul 24, 2008 | HP Photosmart C5180 All-In-One InkJet...

Not finding what you are looking for?
ASUS Terminator 2 Barebone Logo

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top ASUS Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18425 Answers

Alun Cox

Level 3 Expert

2678 Answers

David
David

Level 3 Expert

781 Answers

Are you an ASUS Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...