Question about Kenwood KDC-MP635 CD Player

1 Answer


I Know this may seem like an easy fix, but i cannot get my deck off of the demo mode. i installed it myself. It will not go to the demo mode select screen like it says to do in the manual

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 78 Answers

Turn the unit onto standby then press and hold the menu button then scroll down to demo using the toggle switch on the right then press and hold the toggle switch for a few seconds and it will change to demo off. It's not too difficult but you are correct, it doesn't tell you correctly in the installation instructions.

Posted on Jan 25, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

How do I turn off the demo mode in my jvc kd-hdr44 radio deck?

Press and hold MENU. Turn volume knob to select group, press volume knob to select item, turn volume knob to select, and then press volume knob to save.

Mar 01, 2012 | JVC Car Audio Receivers

1 Answer

How do i get my kd-g385 off demo mode?

KD-G385 doesn't seem to be the right model
Try this: Press and hold SEL button until menu appears
Using the scan buttons (FWD/REV), select DEMO
Using the volume know, set it to OFF
Press SEL to save and exit

Jan 25, 2010 | JVC KD-G340 Car CD/ MP3 Player

1 Answer

How do I stop the JVC from wasting the readout on KM200?

Hello mwalkercom

It sounds like your JVC is still set for factory default which is "DEMO" mode.

To cancel the DEMO, you need to go into PSM (personal settings mode).

1) Press and hold SEL until the display changes.
2) Press left/right rocker until DEMO is displayed.
3) Turn volume knob to change to DEMO OFF.
4) Press SEL briefly to exit.

Now you can use the DISP button to change the display to show the options you desire.

Hope this helps.


2 Answers

My kdc 138 is acting weird

CLICK HERE for your owners manual.

To exit DEMO mode - (see page 12)

And also pull the radio and check the brown TEL mute wire is not touching ground to activate the Telephone Mute option.

It should be taped off or terminated and is not used in your installation.

Thanks for using FixYa - a Very Helpful rating is appreciated for answering your FREE question.

Aug 08, 2009 | Kenwood KDC-138 FM / AM Receiver

1 Answer

I need to know how to set the time and howto put it off demo mode

Press and hold SEL until menu appears
Using the scan button (FWD/REV), select Demo
Using the volume knob, set it to off
Using the scan button (FWD/REV), select Clock h or clock m
Using the volume knob, set the value
Press SEL to save and exit

Jul 07, 2009 | JVC KD-G340 Car CD/ MP3 Player

1 Answer

My cd player in demo mode how i change it

Press the Selection button about 3 seconds
When the Demo On mode appears
Turn the VOLUME dial until Demo Off appears
Press the Selection button again to get out of this mode.

Jul 26, 2008 | JVC KD-G120 CD Player

6 Answers

Stuck in demo

I had the same issue and was about to give up.
cleaning, key combos and such didn't work out.

Solved the dirty way, as described some comments above:

"Just took the faceplate from the "push-menu" button and hit it against a hard surface [not too hard but not too soft hits] and thats it, it worked again."

ah, the good manners!

Jun 07, 2008 | Aiwa CDC-X504MP CD Player

1 Answer

Inverting color display

To cancel demo mode: While unit is OFF and ignition is ACC or ON, press "display" to cancel.

To cancel reverse demo: While unit is OFF and ignition is ACC or ON, press "band" to cancel.

You can also use the MULTI-CONTROL to turn demo mode OFF.

May 15, 2008 | Pioneer DEH-P5900IB CD Player

1 Answer

Cant turn off the demo mode

There is often confusion in the way the manual states how to achieve removing demo mode. Because this is listed in the "Menu System" section of the manual and assumes you read from page 1 of the manual that you will know to enter the menu in this section of the manual. Here is step by step instructions on removing demo mode on your unit. 1. Go to standby mode 2. Press and hold the menu button till the menu comes up 3. Press control knob towards AM or FM to scroll through menu till you locate "Demo On" 4. Press control knob straight in for approximately 3 seconds till it switches to "Demo Off" 5. Hit menu button again to exit menu

Apr 05, 2007 | Kenwood KDC-MP732 CD Player

1 Answer

Demo mode problem

From the user's manual (pg.23): 1. Select the Demonstration Mode. Push the Control knob towards [FM] or [AM]. Select the "DEMO" display. 2. Set the Demonstration Mode. Press the Control knob for at least 2 seconds.

Feb 13, 2007 | Kenwood KDC-MP232 CD Player

Not finding what you are looking for?
Kenwood KDC-MP635 CD Player Logo

Related Topics:

519 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenwood Car Audio Receivers Experts

xxxxxx xxx

Level 3 Expert

4681 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Pablo Gonzalez

Level 3 Expert

733 Answers

Are you a Kenwood Car Audio Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides