I just got one and i opened it. it didnt cut on. but if i plug it up to my computer it turn blue. y is that?

could be coming from the heater core...blend door actuator could be stuck open

Switch off TV, switch off power, remove plug and wait for 48 hours and retry. If problem persists, I suggest it is better to refer it to a qualified service technician, since the back cover has to be opened for investigation/rectification.

Any resolution to this issue? I like stone234 have narrowed it down to the cricut not getting power past the power board. I tested the two prongs that feed the red and black power for the main board and no voltage. Cricut Exp 2. Powered on as soon as I plugged it in. Plugged in usb to computer, I didnt have the software so i searched for it then started downloading it and noticed the screen on the unit was frozen. unplugged it and after plugging it back in it wouldn't power back on.

Step1: The light on the monitor is blue when it is on? And orange when in sleep mode? Check to make sure all the cables are plugged in completely. Perhaps the video cable attached to the CPU is loose. Step2: First of all, check all the cables and make sure they're all securely connected. if you can, hook up your computer to a different monitor and see if it was the monitor. If that didnt work, you may wanna open up your computer and check to see if the video card is in place and fully in. And if that doesnt work, if you really wanna go the extra mile, borrow a friends video card, install it, and try to boot up your computer. Best Of Luck

Check the fuel filter in the fuel tank for plugging. The primer bulb only affects starting. Make sure the muffler is not plugged. If these things look good, try turning the 'H' needle on the carburetor CCW about 1 turn. If this allows the engine to run without the choke, allow the engine to warm up. Then, open the throttle full on and turn the H needle back CW until the engine begins to speed-up, but is still 4-stroking. Correct adjustment is when the engine will smooth out as soon as it starts cutting, but 4-strokes when not cutting. Hope this helps!

you should try switching the sata port you plug your new drive into. also, you should go into your BIOS setup f2 and save setting then exit.

Is this a six way plug (six round holes)? If there are six wires coming from the trailer, then the color code should be as follows:

White - Ground
Brown - Tail Lights
Yellow - Left Turn
Red - Stop
Green - Right Turn
Blue - Auxiliary Circuit (Battery Charge, Electric Brakes, etc...)

If you open the plug up that was cut, it is labeled as to which goes where.
TM = Tail Lights
RT = Right Turn
LT = Left Turn
S = Stop
G = Ground
Center = Auxiliary

when Ur phone is on go to Ur settings and go to Ur sound or vibrate section and turn off the vibrate it over and when u what to turn on don't open that go to Ur nearest mobile shop ask him to solve OK buy OK and please rate me if u used my answer ok all the best

make sure the battery is fully charged, then disconnect from your computer. Wait a while for the device to cool and try turning it on again. Mine took a few tries but once it sat for a while it didnt fight me again.

restore your computer it will fix the problem