My flash does not seem to be working, I tried just about everything but it wont work. it all started when I pressed reset im pretty sure, but im not postive. please help me.

i have the same problem too. im trying out alot of ways to get it sorted. non-seem to work . therefore im trying a hard reset and factory reset on everything. my battery seem to have failed me too. that's pretty weird. i took care of the battery too. =(

Usually the errors are related with the cartridges being empty or having another issue ..or a paper jam is detected..So check it for paper jam ..than check the cartridges..(if you didnt used it in a long time ..they may be dry ..and this model do not support well refilled so need to be changed) ..after checking all that ..try to reset the printer ... Im not sure about the procedure ..but try first to power reset it ..While it is on ...remove the power cable and after a few minutes..insert it back ..than press the power button and keep it pressed for 15 seconds..and see whats going on ..On the net I didnt found a reset procedure ..but it may be available if you consult the support site..

It's a little button above your right knee. Try turning the ignition on (without starting it)... then press the button for about 5 secs... then start it. Should be out then.

the alarm seems to be activated. press the button and turn the key.

i think that your bios is burned up . check if the bios's sticker is of or burned if it is then the oc goes to "happy land " or a new bios

It might not have enough fuel pressure. Try spraying carb cleaner into the throttle body when you crank it to see if it fires.

The car seems to have functioning parts but it is probably a wiring issue - have you done a heater core replacement or anything under the dash/hood in a while (other than "tapping on the starter" <-- which you shouldnt do by the way)

what year is it??

if it is a 1990 the car has a plug undone under the driver side steering column on the "security" and "ignition" wiring circuit - read your FSM (factory service manual) and diagnose the problem. it is definately a short somewhere!

try this plz dont for get to rate
1. Turn the printer off.
2. Hold down the ink and paper buttons, and turn the printer back on.
3. Within a few seconds, the paper light will start flashing quickly. When it does, let go of both buttons.
4. Within 3 seconds press (and hold) the ink button.
5. Hold it until all three red lights start flashing (about 10 seconds).
6. Let go of everything.
7. Turn the printer off, and back on.

Trust me dahaka is right with this i just changed my face, put it back together and i had the same prob. Tried what dahaka suggested and it worked thanks dahaka