I tryed to scan something and all that happens when i press the scan button is the power button light blinks whats the matter is it broke or am i doing it wrong can u send me a step by step guide on scannig with the hp deskjet all in one f4280 thanks james can you ley me know by email: [email protected] as well as fb

try 08.

Watches dont just break overnight! :-) Something has happened, could be dirt around the light button and it might be stuck. I'd have the battery tested as well, and some combo digital/analog watches have 2 batteries! Take it to a reputable watch repair shop! :-)

OK so do led lights on the on the bottom of the controller just keep blinking or ever light up under "1" to signify that it is connected? What you do if they keep blinking is take off the battery cover on the remote and press the red button and the red button under the sd card cover at the same time. This syncs the wii remote with the console. You will need to do this with all new wii remotes.

• Manually turn on the device you wish to scan for (e.g. TV)
• Perform Power Scan by pressing and holding (approximately 3 seconds)the desired DEVICE MODE button TV, VCR, CBL, DVD or SAT until the status indicator light begins to blink.
• Press and release the PWR (power) button. The status indicator light will stop blinking and stay ON at this point.
• Press and release slowly and patiently the blue UP ( ? ) button to scan forward through the code database. To scan backward through the code database, press and release the blue DOWN ( ? ) button. Each time you press the up or down arrow, the remote will try and turn off the device (TV, VCR etc) you originally selected.
• When the device (TV,VCR etc.) responds by shutting off, press the ENTER button. This will store the code
• in memory and you will see three blinks of the status indicator light to confirm the code input. Be patient, there are over 100 codes to search through.

try cycling the power on the back of the console
are the lights blinking on your controller when you press them?

doesn't sound like it is installed properly, try uninstalling and reinstalling, also checking the manufacture site and see if there are updates to download for it

If its a four digit code remote. I may be able to help.. Try these...0171, 1204, 1326, 1517, 1963, 2002..
Good luck

http://www.remotecodelist.com/remotes/jensen/JR300C.pdf

that is standby mode! maybe you have defective power supply in oscillation circuit! at hot side..