Photocopier doe not function

If you have the install disc , Go into remove programs and uninstall it . then reinstall it . up date as there may be a new driver for it.

The problem is with the toner....there is two way solution change toner or more economic way change the chip of your existing toner....the sharp copier tend to burn the toner chip.

U should apply it # int c int. Then14 start

sharp ar 5516 showing ( - - - ) what's the solution

exposure problem

Ch means the side door is not closed or the toner is not installed correctly.

H-4 is a fuser low temp indicater. Use simulation 5-2 to check fuser lamp. If lamp checks good move on to next problem (it will light up..trick door switch so you can see the light from end of heater unit) The thermister could be dirty or defective(fuser must be dismantled to clean)

Sharp AR-5320 photocopier/printer is in share network. for each printing command ,its asking to install driver.and its taking more time for printing..

H4 heater problem.

lamp in the fuser not turning on, either lamp or themofuse is bad