Busted belt want to replace with new need a picture of what a properply instaled belt looks like so I can do it myself

1 phase suggest replace capacitor or wingdings in motor are damaged/ or it could be a bad electrical connection /supply to motor
myself i go for capacitor good luck.

Hello, I feel your pain as I have busted many of the reducilous tabs myself.You will win the lottery before You get replacements.I use to drill a new hole and install a screw to secure the door.Duct tape works but does not last.

sounds like the rollers or the belt has bust ..this is the drive system from the engine...if it runs & revs but does not move....i would be looking under the drive cover on the l/h side of the engine caseing...as its either a belt or roller problem....hope this helps

An authorized service center would have to order you new screens. Most servicers will not :(

I went to the local library, studied a motor manual from their reference desk for about an hour and went home. With my next door neighbor's help, I busted some knuckles and installed the new belts in about an hour.

That was Saturday, 3 hrs. after I contacted your site.

yes easy,look for your tension wheel,its will take a 3/8 rachet with out a socket it will release the tension so you can put your belt on.There is a picture on the top of the rator case how to put it on right

I haven't worked on a belt drive but here is the Sears parts site for your washer with diagrams of the console, drive system etc. You may get a better idea of how to replace the belt from these.

Here also is the Whirlpool / Amana installation and maintenance document for Amana belt drive washers. It may look similar to yours.

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6/56310258b0952a4e8525729c0056d75b/$FILE/Amana_Searcy_TL_Washer.pdf

The other thing I'd check is Whirlpools list of documentation for their laundry products. Check some of the washers that they make for one that looks like yours and you should get a better idea.

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6?OpenView&Start=1&Count=30&Expand=6#6

if the remove the lamp and you have seen it is busted try replacing it with a new if it is not check the ballast.

then in all honesty i would be looking at a head job to replace the bent valves and maybe evan a new piston if the crown has a hole in it?? ,plus the new belt and whatever in the way of the covers

not likely. You may have to remove the upper intake manifold for access.

go to site for picture of heater hose diagram
http://autos.groups.yahoo.com/group/villagerquest/