Question about Fetco International CBS-51H-10 Coffee Maker

1 Answer

Not heating Our Fetco CBS-51H does not heat water. All lights come on, will run brew cycle wit no problem, just cold water. I suspect a heating element malfunction but how can I verify this?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,039 Answers
Re: not heating

Yes just remove the cover lot of time it just thr femelle therminal that overheated cut the old therminal clean contact put a new therminal cheers

Posted on Jan 21, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

When I brew on one side of my Fetco cbs-52h, both sides brew. Any idea?

Refilling water in the tank does not stop at the appropriate level. Is much higher than the height of the level sensor which causes the other party also poured water. Descaling of the level probe should solve the problem.

May 04, 2014 | Fetco International Coffee Makers &...

1 Answer

Fetco cbs 51h drips water

Replace the brew solenoid on top of the sprayhead. Either something is keeping the spring and gasket open or the gasket is damaged. Get a rebuild kit from fetco or a new brew solenoid.

Oct 02, 2013 | Fetco International Coffee Makers &...

1 Answer

When I press down on the hot water tap, no water comes out. What should I do?

Inside the faucet is a rubber membrane and this has become detached from the handle. You can order a replacement faucet from the Fetco agent in your area. Swapping it out a simple process requiring only basic hand tools.
Turn the machine off and remove the left side panel. Behind the side panel you should find a clear silicone pipe. Remove the bung in the end and drain water into a bucket or drain. Once level is low enough, you will be able to remove existing faucet and replace with new one. Reassemble, turn on machine and allow to fill and heat.

Sep 21, 2013 | Fetco International CBS-51H-10 Coffee...

1 Answer

Cbs 2031 will randomly push 2 0nces to 30 ouncec of water out overflow next to spray head

The bypass valve is letting by and needs to be replaced. You should be able to get one from your local agent and swapping it out is a simple enough task requirring only basic hand tools and some PTFE tape.
Access to the valve is via the top cover and the valve is located logically close to where the water is leaking, just follow the pipes.

Jun 23, 2012 | Fetco International CBS-2031

1 Answer

Fetco cbs-51h coffee maker not heating hot enough. turned thermostat all wasy up. coffee luke warm.

It can be the Temperature sensing probe, heating element or a loose/burned wire connection.
Adjusting the brew temperature is not going to help

Jan 17, 2011 | Coffee Makers & Espresso Machines

1 Answer

Fetco coffee brewer CBS- 2052 error 102 unwanted fill

Probably the filling valve allows water when is in a close position.

Jan 23, 2009 | Fetco International CBS-2052

1 Answer

Fetco CBS-31Aap over brewing

It's possible that your airpots are too small. We have the same machine and 3.0 litre airpots and it's perfect. But I can't find the right filters for it! I'm currently using a bunn filter and MOST of the time I end up with a lot of grounds in my coffee.

Jun 18, 2008 | Fetco International CBS-31AAP

Not finding what you are looking for?
Coffee Makers & Espresso Machines Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fetco International Coffee Makers & Espresso Machines Experts

Ernest R
Ernest R

Level 3 Expert

1618 Answers

Barrett Palumbo
Barrett Palumbo

Level 2 Expert

1772 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Fetco International Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides