Question about Hard Drives

1 Answer

Requarment sir i have 2 hardiskfor ibm model no dcas 343330 e 82115l2 i have no deta cable so u can sugest me witch type of datacable support

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 20 answers of more than 400 characters.


    An expert who has answered 20 questions.

  • Expert
  • 113 Answers
Re: requarment - Hard Drives

SATA 2.0

Posted on Jan 31, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Manual for Seagate hard drive model no. ST31005EXA101-RK

The Model Number You Have Is Incorrect!

You Are Looking For The Right Model Number Witch Is
ST9100801U2-RK Armed With This Info, Go To The Seagate Web Site And Click On Support And Type it In And Press Enter And You Will Find The Downloads You Need!

Feb 15, 2014 | Seagate FreeAgent Pro - 500GB, 7200 RPM,...

1 Answer

I need a new a new cable (fits an unusual 5-pin socket) for an ibm travelstar external hard drive

the dearlership should know what you need. the reason the socket is so different is to let you know, the stuff in which contained in this part is very sensitive and could major problems if you are not sure what your doing

Apr 13, 2012 | IBM TravelStar 40GN 20 GB Hard Drive

1 Answer

My hard disk was being used in an HP machine now it cannot be detected by the machine or any other machine the harddisk is hitachi deskstar model HDP725025GLA380 help me

dear sir,
i think your hard disk is broken.. try to put your hard disk in a refrigerator for one night and then try to connect again to your machine, if you still get the same problem i think you need a new hard disk

May 17, 2011 | IBM HITACHI Deskstar P7K500...

1 Answer

Dear Sir/ Madam, I have TWO Western Digital USB

first of all , you are looking at the wrong voltages. The important voltage is the DC OUTPUT, which is the voltage the external harddrives use AND the polarity of the plug attached to the harddrive end of the cable.
if both the harddrives have say 12v dc output and both have the insignia of the center conductor being + (posative) then you can interchange them. and you CAN run a 9volt unit with 12volt DC power, but not the other way around.
Look at your power adaptors again for the OUTPUT and polarity.
should be a half-circle with lines depicting the polarity(+,-) of the center and sheild connections to the hard drives printed on both the harddrives and the power adaptors . This can also be tested with a dc volt meter while the adaptors are plugged into the wall.
DO NOT try to test the AC end while plugged in!!

Aug 09, 2010 | Western Digital 250GB MyBook External USB...

3 Answers

How do i install a used hard drive into an eMachines T2341? The hard drive still has information on it. do i set it as master, slave, or cable select? hard drive is an IBM 10.1 gb

There are two possible solutions depending on how your desktop is setup.
#1 install the 2nd hard drive and put jumper to CABLE SELECT. When you start the computer it should now appear in the bios as a SLAVE or 2nd hard drive. If not go to #2 below
#2 Turn system off again and change jumper on 2nd hard drive to SLAVE.
Now when your computer restarts it will appear in your bios correctly as the 2nd drive/SLAVE.
Do not make it "MASTER" or you will be trying to boot up to this drive and it may not work as you planned.

FYI: "Cable Select" means the hard drive determines which one is Master and which one is Slave by where it is on the data cable.

Good Luck

Dec 30, 2009 | Hard Drives

1 Answer

IBM Deskstar 120GXP 123.5GB

That model acer is a newer system; pentium dual-core; so bios limitations should not be an issue. With the 120GXP older drive; check that the 32GB jumper is right. The pins have a label (red text) on the back; ensure it is set to master (according to the far left label) not the right. It will take 2 jumpers; not just one. See how that works. Also, check your bios settings; and ensure the IDE power ... is enabled. (for example secondary) may be disabled. Or, check that "legacy" support is enabled in the bios. Please rank me if this helps. Please check me out on facebook

Feb 22, 2009 | IBM Deskstar 120GXP 40 GB Hard Drive

1 Answer

Getting files off an old IBM TravelStar 20 GB Hard Drive

You can buy an adaptor that will connect your hard drive to a pc.
Ribbon cable from your secondary drive on pc goes into the adapator. Adaptor also coonects to laptop harddrive.
You also need to change from being a master driveto be a slave drive . see linkbelow.

You can then copy file to pc a usb memory stick.

Oct 13, 2008 | IBM TravelStar 40GN 40 GB Hard Drive

1 Answer

Deta recovery

there are programs you can run to recover pictures (it's what i do alot of)


Sep 02, 2008 | SanDisk 2GB Cruzer Micro SDCZ62048A10 Hard...

Not finding what you are looking for?
Hard Drives Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hard Drives Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers


Level 3 Expert

281 Answers


Level 3 Expert

5660 Answers

Are you a Hard Drive Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides