Question about Jensen JMP12 Consumer Microphone

1 Answer

I hate YOU

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,067 Answers
Re: i hate

Ya well buy new mic thats good like at4040 ok then it will hate u for spitting in it

Posted on Jan 21, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Shure SM58 Ticking Noise

Try turning off the phantom power required to use for the v67. Check connections on the 58 by removing the connector where the xlr connects, and making sure that's looks good. hope this helps.

Feb 25, 2010 | Shure SM58 Professional Microphone

1 Answer

Two diffrent units with two diffrent frequincys . i wantto change

I hate to be the bearer of bad news but those units are fixed frequencies and cannot be changed. You either have to find a mic that matches your receiver or vice-versa. The freeway 200 series comes in 3 freqs. two of witch you have with the addition of 170.245. Maybe you can find someone who has a damaged mic but still has the receiver with the freq. that you need for your mic.

Apr 11, 2009 | Audio Technica Audio-Technica ATW-T202...

2 Answers

I have an ECM-MS907 Sony mike. I started having some issues with a wierd buzz and then I realized that my cord was frayed. Is there anywhere I can get a replacement cord? The issue I see with replacing...

I had a similar problem with my ECM-MS907.
The cable had broken near the mic and the right channel would drop in and out as i moved the cable.
Unfortunately the only solution is to open up the microphone, unsolder the cable, cut out the broken area and solder in the remainder of the cable.
I did this this morning and it was quite tricky. It's easy to open the microphone (3 screws) and the 3 solder pads (left, right and ground) are large and easy to solder to. The big problem is that the wires for left and right channels in the cable are very fine and insulated with enamel which is hard to strip (try just burning it off with the tip of the soldering iron). 
Anyway, a bit of an involved fix... I wish this mic had a 3.5mm socket on the bottom  instead of having the cable soldered in. I hate stuff that's not easily replaceable.

Dec 09, 2008 | Sony One-Point ECM-MS907 Consumer...

Not finding what you are looking for?
Jensen JMP12 Consumer Microphone Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jensen Microphones Experts


Level 2 Expert

611 Answers

Ben Armstrong

Level 2 Expert

332 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Jensen Microphone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides