Question about Projection Televisions

1 Answer

I need instuctions on how to set up a Orion 5000hd plasma flat screen television

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Projection T... Master
  • 8,617 Answers
Re: I need instuctions on how to set up a Orion 5000hd...

I havesearched all over cant find any listings anywhere for an Orion 5000hd.Are you sure you have the correct model number?

Posted on Jan 22, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Is this tv hd ready?

Yes, it should be HD ready. There should be a small label on the front of the TV if so (provided it has not been removed). You will need a HD cable box, convertor or HD satellite box (Direct TV or Dish Network) to view HD broadcasts (even from free over-the-air HD broadcasts if you live within range of a local broadcasting station). I had the same, or very similar TV but upgraded to flat screen plasma set.

Aug 14, 2012 | Hitachi 53SBX01B 53" Rear Projection...

1 Answer

The screen is cracked and distorted can it be fixed the inside is not on the outside Mitsubishi 42 INCH FLAT SCREEN TV serial number LT46133

IF it is a LCD OR PLASMA AND SHOWS A CRACK INSIDE THAT IS can be seen---you are finished.

It means Panel is damaged internal--cost of part alone will be as much or more than set cost, not counting labor(major).

I do not like giving bad news. If you have questions or need advice comment on this solution

If this told you something you did not know rate this solution very helpful as I do this here for free.


Aug 24, 2010 | Mitsubishi Projection Televisions

1 Answer

On a plasma, what board would be responsible for performing convergence?

Plasma TV does not have such thing like convergence or does not require convergence.
Plasma TV is flat screen and every pixel in plasma panel produce its own light to make color picture.
Convergence section is part of old fashioned rear projection TVs that has 3 CRTs to project color image on front screen of TV.
Hope this info will help you.
Let me know if you have additional question.

Jan 07, 2010 | Projection Televisions

1 Answer

I dropped my Samsung flat screen TV and the inside screen is broken. Can this be repaired?

No, it cannot be fixed.

The part is called a display panel and even if it is available the cost of such a part is more than the set cost when new.

LCD AND Plasma panels are very fragile.


Oct 27, 2009 | Hitachi 65F59 65" HDTV

1 Answer

Red blinking light

If the red lights comes on and stays on, you will need to replace the lamp. However, if the red light blinks repeatedly, your internal motherboard was either fried during a recent power surge, or the circut board will need recalibrating. In short, you will need to contact a cert. technician to re-initialize your set. It may be more cost-efficient to purchase new flat-screen plasma set. Good luck with your investment.

Jan 05, 2009 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

30" samsung flat screen powers on but tv screen black. sound is good. Worth repairing?

It depends on what kind of t.v., plasma or LDC. and does the screen appear to light up or do nothing (if you turn off the lights, does it glow black like there is no signal or is there nothing at all?) If it is an LCD and the screen is bad then investing in a new one. A plasma might be worth fixing depending on how much a new one of comparable or better quality would cost. It doesnt sound like there is something wrong with the computer/board in it so that shouldnt need to be replaced.

Oct 19, 2008 | Projection Televisions

1 Answer

Picture dark

Please check its G2 (grid) volts, should be approx 600-700 volts dc. In some sets it calls Screen Volt.

Aug 09, 2008 | Toshiba 42H83 42" Rear Projection...

1 Answer

Philips plasma problem

What is the model number of your set. I may be able to help you if you post the model number.

Mar 08, 2008 | Projection Televisions

1 Answer

Mitsubishi projection tv

Since a PIP set has two tuners it sounds like the chroma circuit on one tuner is shot. Now this fortunately is a less expensive repair. If the set is fine otherwise then go for the repair but first get an estimate. It will be cheaper than a plasma flat screen of similar size. A reputable repair shop should charge no more than $300 (should be less) MAX for this repair.

Jun 29, 2007 | Mitsubishi VS-45607 45" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers


Level 3 Expert

57192 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides