Question about Whirlpool Ultimate Care II LSQ9549L Top Load Washer

1 Answer

Everything is working fine other than the bottom part of the agitator, it will not spin the clothes

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clothes getting twisted around agitator


That does not sound good. New dogs sound great, but you must get to the bottom of why the clothes are becoming twisted on the agitator. Usually not enough WATER. Think loose flow of clothes submerged.
Long story short, you cannot jam pack this machine. Less clothes, more water, will equal long life.
Be sure that the mating teeth for the dogs, is not damaged. Slipping here would make loud noise.
More water, less clothes.

Apr 04, 2018 | Kenmore Washing Machines

1 Answer

The machine is working but the agitator is not


Agitator dogs are worn out. These are what grab the agitator and agitates the clothes. The dogs have fine teeth and are worn easily if the washer is overfilled or off balanced. The top of the agitator spins off, down inside at the bottom of the agitator, the bolt will come out and then the agitator can be lifted out. Here you will see the dogs. I included a picture of what they look like15b7d98.jpg. Easily repaired and take 5-10 min to repair. The dogs are about $5

Feb 03, 2010 | Washing Machines

1 Answer

Old Kenmore gas dryer Model 870692800 aka lady Kenmore Ultra fabric Care blower works, warm air enters chamber, but canister(?) holding wet clothes does not rotate. Ran a load of clothes earlier in day,...


if the tub will not agitate i would first take out the agitator, (there may be a bolt in the top holding it onto the transmission shaft), and check the top of the agitator to see if the splines are stripped. try to run the machine without the agitator on the shaft and see if it will agitate. if it is a case of the machine not spinning out the water after the wash cycle, you may have a burnt wire from the control magnet assy. at the bottom of the gearcase. there are 2 bars and 2 solenoids with 2 wires going to each one, these wires can break or burn off and the machine will not go into a spin mode. hope this helps.

Oct 15, 2009 | Kenmore Washing Machines

1 Answer

Spin cycle is not working right,


This is a problem in your transmission. Not Good!

May 18, 2009 | Washing Machines

3 Answers

Kenmore washer 80 series 110 model not spinning.


unless your washer is over 20 years old, then it wont have a belt. the temperature of the water wont have anything to do with it spinning or not.
need to know if it agitates or drains and just wont spin.
if it agitates but no spin or drain, then you have a bad lid switch.
if it wont agitate or spin, but will drain, then you have a broken drive coupling.

Jan 08, 2009 | Kenmore 24032\24036 Top Load Washer

1 Answer

Kenmors 110 keep spining


The tranny should either spin or agitate not both

Nov 02, 2008 | Kenmore 24032\24036 Top Load Washer

2 Answers

WASHER AGITATES WHEN SUPPOSE TO SPIN


Faulty spin windings on motor. Regards Advisor

Sep 01, 2007 | Whirlpool Ultimate Care II LSQ9549L Top...

1 Answer

Everything works but machine won't agitate


The pull at the bottom of transmission should turn both ways.. one way for spin the other way for agitate... if transmission turns both ways means not locked up and probley bad motor..

Jan 06, 2007 | Amana LWA40A

Not finding what you are looking for?
Whirlpool Ultimate Care II LSQ9549L Top Load Washer Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Sal De

Level 3 Expert

2699 Answers

Marvin
Marvin

Level 3 Expert

83096 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1474 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...