I just bought a PD-M403, and it turns on great but it says no disc. I took of the cover to look at it and the cd went in and just sat there not moving. Then it switch to disc. 2, same thing again, and switched to disc. 3, repeatedly. What shuld i do??
An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: HELP ME PLZ!!!
Open the player wit the door ejected then clean all dust particles
inside it especially below the door and on the way where the door
closes ... and then also clean the rubber belt & near by which is
connected to dc motor... and clean the lens also... remember clean
only wit dry clothes...
it jumps to disc 2 may be there are dust particles which make struck... so clean it clearly and try...
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Mine did the same thing. My player was primarily used in the garage and the cold weather may have caused my player to do the same thing. I just fixed my player. I removed the top cover and looked at the CD in the play position. In the upper right corner from the CD, you will see a spindle motor with a belt on it. Gently spin the motor back and forth carefully with your finger. I rotated it a half-spin in either direction, careful not to dislodge the belt. When I turned the player back on, the mechanism operated as it normally would and began playing the disc. I was able to eject and reinsert the magazine without any issues, solving the problem. Hopefully that will work for you.
Try this: 1) Disconnect the powercord from the plug!! 2) Remove the cover 3) Reconnect the powercord, turn on the power and press eject. 4) Turn of the power - beware, there is still power on the trafo!! 5) Now you have to carefully clean the laser (round glas-like item in the middle of the drawer) with a cotton swab filled with isopropyl alkohol. 6) Then wait at least 1 minute. 7) Turn the power on again and try to play a cd. If it works as it should then you have succesfully repaired your cd-player :-) Otherwise you may try again. 8) Now disconnect the powercord and replace the cover.
If this doesn't help I'm affraid you have to turn it in to your local shop for further invistigation and repair...
My kids always cause this one ! Switch off power, remove cover. Remove four screws holding top black plastic disc cover and then remove all of the black plastic ( x 7 ) disc holders. You may find that the aluminium cross structure has come adrift. Replace into the slots again and replace all the disc holders. If you want, you can check before replacing cover, by then ejecting and 'disc skipping'. It should thne be ok. If it has been forced, the aluminium cross structure thing may have also come out of the slot it should in in on the right hand side. Slide the disc frame in or out until it can be fitted and retest.