Question about Radio Shack Cinego D-1000 Multimedia Projector

1 Answer

Unit keeps shutting of by itself

Why does my unit keep shutting off, i've had the unit for 2yrs

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 115 Answers
Re: unit keeps shutting of by itself


Pls Clean the air filters and check the lamp runtime.


Rave Services India

Posted on Jan 21, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

My viewsonic cine1000 shuts itself off after about 15 -20 min of playing. The bulb has about 500 hours on it. Why does it keep shutting itself down? It doesn't turn itself to standby either, the...

Make sure the PC itself is not going into a power saving or screen saver mode...this is the most common issue when playing completely automated presentations or movies.
Normally, I suggest turning off all power saving functions in the PC or Laptop, and disabling the screen saver all together.

Jun 20, 2011 | ViewSonic Cine1000 Multimedia Projector

1 Answer

Keeps going to double red light shuts down, then it resets and turns on for 5 minutes and then turns off again, what could be the issue? thanks

I've seen this happen almost exactly on a Canon projector. The problem was the bulb. After the bulb was replaced the problem went away.

Please remember to rate this solution to show your appreciation!

Jun 01, 2011 | Epson PowerLite 7900P Multimedia Projector

1 Answer

Curious as to why my InFoucus LP860 has blue in the corner and also runs down the side of the image... its a consitint....connected to a source or not.

This is heat damage to the lcd panels due to the projector not being shut down properly. When the unit has been on for any lengthy period and it is shut off using the on/off switch on the rear of the unit, this shuts the whole thing down, fans and everything. If it is shut off using the on/off buttons on the remote or on top, the fans keep running until the unit is cooled and then powers itself completely off. The damage is only fixable by replacing the light engine and if not under warranty is very expensive.

Oct 08, 2010 | InFocus LP860 Multimedia Projector

1 Answer

I have a Luxeon v1 that runs for about 1-2 hours and then shuts itself off. The bulb is off but the fan is still running. I am unable to turn off the projector and I have to unplug it from the outlet to...

First of all, DO NOT unplug the unit until the fan stops. The fan should continue to run until the lamp has cooled down completely. This is normal. If the unit is shutting down on its own, perhaps the fan is not working good enough. Check for debris in the fan area and be sure that there is enough ventilation to keep the unit cool. The shutdown may be a safety shutoff because of heat.

Check the fans and update this with what you find.


Nov 03, 2009 | Luxeon V1 Multimedia Projector

1 Answer

Sony projector

clean the air filters of your projector.. if problem still the lamp ballast of your unit was defective.

Oct 23, 2009 | Sony VPL CS3 Multimedia Projector

2 Answers

I turn tv light comes on but i get no picture or audio....then light indicator blinks red

Lamp or ballast(if lamp has been replaced) is bad.
Explanation: green comes on: system works, waiting for light to shine into light engine: no light is coming out of lamp, system shuts down, then you see red! how to determine: pull the lamp out of the unit's compartment. Inspect lamp: bloated stem? shuttered? reflector is not shiny? Chuck it!
Lamp looks good or just been replaced: try ballast. Close lamp compartment without lamp itself. Make sure, door is shut, as well. Turn unit on and listen close to lamp compartment: good ballast will make a buzzing noise, then stop. You've got "red'! No buzzing: ballast quit. Needs major repair! Lamp must be good, for sure, to get to the last part of diagnostics. Conclusion: more, than 2000 hours of usage: replace lamp first!
Good luck,

Jul 29, 2009 | Panasonic PT-D5600U DLP Projector

2 Answers

My in1 projecter keeps turning itself off

if the lamp has 2000 hors on it, it needs replacing. go into the menu and find out how many lamp hours are used. it could be the lamp and it could be the ballast.

Nov 23, 2008 | InFocus ScreenPlay 4805 Multimedia...

1 Answer

Infocus led diagnostic

it might be overheating. clean off the dust filters (bottom towards the front). if there's not enough airflow to cool it down, the projector will shut off to save itself from damage.

Jul 01, 2008 | InFocus LP210 Multimedia Projector

Not finding what you are looking for?
Multimedia Projectors Logo

Related Topics:

312 people viewed this question

Ask a Question

Usually answered in minutes!

Top Radio Shack Multimedia Projectors Experts


Level 3 Expert

2236 Answers

xxxxxx xxx

Level 3 Expert

4679 Answers

Martin Murray

Level 3 Expert

1614 Answers

Are you a Radio Shack Multimedia Projector Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides