Question about Champion International Air Tools & Compressors

1 Answer

Oil leaking from blowoff valve - Champion International Air Tools & Compressors

Posted by on

  • compman66
    compman66 May 11, 2010

    What model?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,167 Answers

Hi bud is it continuous oil blow off or is it a bit as if its to much then your piston rings have had it buddy

Posted on Dec 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Installed blowoff valve on Saab 93 2004 but not working


You should not install an open air BOV on SAAB's latter than 1999. Rather you can install a forged aluminum version that still evacuates the boost into in the intake pipe just like the factory version.

Nov 30, 2013 | 2003 Saab 9-3

1 Answer

Blowoff valve


Somebody get hot. I assume it is the relief valve on your hot water heater, just replace it if it has failed. Before you do that check the water temperature, it may be set to hot.

Nov 03, 2013 | Plumbing

1 Answer

1998 Chevy Malibu is using excessive oil. Had an oil change done back in October 2012 . Then checked Oil level in December of 2012 and was about 3/4 low in oil! why ?


first thing check make sure oil pan drain plug tight. check make sure oil filter tight. try tighten oil filter by hand see if turn tighten oil filter clockwise direcction if all is good. how many miles on vechicle.could have oil leaks park vechicle in spot that clean.move vechicle see if you see oil spots on ground if yes.your front timing cover seal leaking oil or rear main oil seal ;eaking.or valve cover gaskets leaking.if find no oil leaks more likely engine burning oil.replace pcv valve.check air filter if you see oil in air filter housing either have bad pcv valve or pcv not getting vacuum make sure pcv valve getting vacuum when engine running vacuum should be felt at pcv if not pcv valve bad or pcv hose disconnected broken or plugged.if pcv valve okay engine has worn piston rings.worn valve seals or guides or oil return holes stopped up thats all possible reasons for engine burning oil.if spark plugs oil fouled engine burning oil.

Jan 11, 2013 | 1998 Chevrolet Malibu

1 Answer

Where is the blow off valve located on the Audi A4 1.9TDi


It doesn't have a blowoff valve it has what is known as a recirculation valve .. blowoff valves vent to atmosphere while recirculation valves reroute the air because it has a mass airflow sensor
img_0010-lkoyevbktyhuhdvtzpbuedev-4-0.jpg

Apr 24, 2012 | 2000 Audi A4

1 Answer

Hot water leaking from what i think to be the pop off valve. i tried to tighten it a little and it started leaking more. The unit is 16 years old. The excess water is draining into the catch pan and then...


Hello
16 yrs old? Im guesing this is a hot water heater.Not a air conditioner.

If its still making hot water you may not need to replace the whole unit.
The valve that is leaking is a high pressur relief valve and they do go bad the sprigs become weak over time and some corrosion may not allow the valve to seat properly.

1st step is to shut off all incoming and out going water to the tank.
2nd Shut off fuel or gas to the unit, and annonce to everyone your are working on the hot water heater.
3rd at the very bottom should be a drain valve much like a hose spicket,open this slowly and drain the tank,remember the water will be hot.You may not need to drain it all the way,while draining pop open the relief valve,when you stop getting water from it,you are below it and can turn the drain valve off.
4th remove old relief valve and replace with a new one,i think they are rated at 15 psi or 30 psi blowoff pressure,hopefully there is a tag on it with that info.

When you go to install your new one use some pipe thread compound or teflon tape around the threads before you reinstall valve.
Once done slowly refill tank with water, check for leaks.When full open up hot water valve to house and relight buner.open a faucet in kitchen to hot to bleed off any air.

Jan 14, 2011 | Heating & Cooling

2 Answers

Valves knocking and oil leak


might still be under warranty might want to check with your dealer

Mar 15, 2010 | 2007 Jeep Compass Limited

1 Answer

For toyota mr2


if its a turbo its called a waste gate

Oct 31, 2009 | Toyota MR2 Cars & Trucks

1 Answer

Cooling gas are leeking from compressor safty valve. What are the causes?


Install ac gauges and check the pressures ensure the high side is not over 275psi. If pressure is high  evacuate system recharge w/specified refrigerant and monitor gauges, make sure the cooling fan is working properly. Could be a defective blowoff valve,fan assy/relay,or a restriction in the system. 

May 07, 2009 | 2005 Ford Expedition

Not finding what you are looking for?
Air Tools & Compressors Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Champion International Air Tools & Compressors Experts

John Trevino

Level 3 Expert

1388 Answers

JOHN LAPIER

Level 3 Expert

2528 Answers

Brad Brown

Level 3 Expert

17433 Answers

Are you a Champion International Air Tool and Compressor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...