Question about Maytag LSE7806A Top Load Stacked Washer/Dryer

2 Answers

Maytag washer I have a Maytag, stackable washer and dryer. Model LSE7800ACW. Serial no. A5128597. The problem that I am having is with the washing machine. Several months ago the agitator started working long before the tub was filled with water. I have a laundry sink so I filled the tub with a garden hose but still had to keep a close watch because it would not turn off at the end of the cycle leading in to the machine trying to agitate again with no water in it. Being my busy time of year I put up with this problem bye by passing the safety switch and filling the tub by hand. After a few weeks the problem corrected itself and it worked fine for the last several weeks. Of course all good things come to an end, I am having the same problems again. I have checked the screens in the hoses and have plenty of water getting to the machine. ANY SUGGESTIONS?

Posted by on

  • 2 more comments 
  • flyponder Mar 20, 2008

    GregG & FixYa

    Thank you for trying to help me out. My problem also started when the power went out while the tub was filling. I don’t find a fuse but I also don’t think that is the problem. The tub wants to fill, but the agitator runs when it shouldn’t. Now instead of turning the machine of and filling with a hose I unplug the motor wire from the “run relay” until the tub is full. By looking at the schematic I think that my problem is either the pressure switch (but the water turns off when full), the run relay (but the relay is not constantly on) or the motor interrupter which I am not sure what it is but I think it might be in the timer itself, also the timer does not shut off between cycles causing the machine to never shut off by itself.

    Thank you again, Flyponder

  • flyponder May 19, 2008

    I found the problem to be the run relay switch was stuck in the on position. Thank everybody for trying to help.


  • Sam09 Jan 14, 2009

    flyponder, Would you please let me know how you verified that the relay was stuck?


  • Anonymous Mar 20, 2014

    Hey I have a Maytag PAV2300AWW and the first problem was the unit overflowed. So I tried blowing in the hose in the top panel and nothing.. Then, it started working again ( the water would turn off when it was supposed to) but you have to change the cycles manually and the machine will not agitate???



2 Answers

My washer will start filling up with water then stop .The green lights start blinking all around the knob.then i have start it again

Posted on May 18, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

This is similar to a problem I had after my power suddenly went out while the washer was filling with water. When the power resumed the washer would no longer run water... all other systems (agitate, drain, spin) worked fine.

A 10 minute, $113 dollar service call revealed that there was a fuse inside the front upper left area that had blown. Remove the 2 screws at the bottom of the front panel to get access to the inside.

Check it out and replace it if necessary.

Posted on Mar 07, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

CHANGE THE DRYER BELT MODEL LSE7800ACW MAYTAG WASHER/DRYER COMBO can go to the following website and check out how the belt goes on the dryer.
On a front load dryer, you would normally remove the front to expose the drum and belt, after you remove the drum then that exposes the drum rollers, motor, idler arm pulley, etc.
Hope this helps

Sep 29, 2009 | Maytag Dryers

1 Answer


FLSE72GCS6 this model number is showin as a complete laundry center, not 2 seperate peices. in which casse there is no seperating them

Dec 09, 2008 | Frigidaire FEX831CS Top Load Stacked...

1 Answer

I have a maytag stackable washer dryer model number LSE7800ACW when i turn on the washer it will not fill it will not spin it will not do anything but the dryer works just fine. What is wrong

HI. thanks for the question. you have a blown fuse ,inside the washer. remove the front panel. on the left ,you will find a small glass fuse .check that. if its failed you will be able to see, that the small metal strip inside the fuse is broken , if so replace the fuse. thanks the appliance doc . please rate my answer.

Oct 07, 2008 | Maytag Washing Machines

1 Answer

Maytag front lead stackable

That is correct. Take the screws out of the console up top. look for a burn mark on your circuit board. If it's on R11, replaced your door lock wax motor as well at the board.

Jun 04, 2008 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag lse7800acw

The motor is faulty. Either the relay contacts are stuck or there is a shorted winding. Best to replace the motor.

Jan 13, 2008 | Washing Machines

Not finding what you are looking for?
Maytag LSE7806A Top Load Stacked Washer/Dryer Logo

509 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Bill Long

Level 3 Expert

588 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

John Tripp
John Tripp

Level 3 Expert

4655 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides