Question about RCA F32650 32" TV

1 Answer


Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 104 Answers
Re: blue screen

It sounds like the Blue drive transistor is shorted out leaving the blue color gun on full blast which is drowning out the other colors. If this is the case the transistor needs to be replaced. A qualified technitian could easily replace this part.

Posted on Mar 11, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Rca tv wont stay on turns on then blue light accross the screen then goes off in seconds

it is listed here as a 27 inch set--can you confirm the brand and model number for me ???

Mar 24, 2012 | RCA F27450 27" TV

1 Answer

I have a RCA 32V432T 36in...the screen is light blue with white horizontal looks like a film in front of the actual picture...there is still audio though. what's going on?

There are two main causes for this fault. The first one is, advanced screen voltage to the screen grid of picture tube. The second one is leaky blue video output transisotr.
Just open your TV, and locate the screen control. It usually can be located with LOT [Line Output Transformer]. There will be two adjustable controls integrated to this LOT, marked as screen and focus. Out of which, the lower one will be for screen adjustment, and the upper one for focus adjustment. Just rotate the screen control [the lower one] to a little counterclockwise, so that the thin horoizontal lines on the screen just fade of. Adjustment is critical and should be done with care, and a small movement may just be enough. If it does not help you, repalce the blue video output transistor. This part can be located at the bace card [the printed circuit board fitted to the neck of the picture tube]. Locate it, replace it. OK.

Apr 17, 2011 | RCA 32V420T 32" TV

1 Answer

Screen is all snow and channel 4 shows in the upper right hand corner. TV needs to be on channel 3, but trying to change it manually does not work; therefore, satellite tv does not work. I've checked...

Check your TVs settings. Check if channel skip option in on. If it is on, this type of fault occur. Turn it to off if it is in on condition. If the blue back screen option is there, just turn it on to avoid grains on unused channels.

Oct 13, 2010 | RCA F32649 32" TV

1 Answer

AV-32F703 has redish flare upper right corner. Is

bulb problem. needs to be replaced. the tv looks a little old maybe yu need a new v for once.

Feb 17, 2010 | JVC AV-32F703 32" TV

1 Answer

RCA TV lost Color

It sounds like your grandson found the "monochrome" setting in the menu on your remote. It may be in the "picture settings", "set-up" or "advanced" setting.

Sep 10, 2009 | RCA 32F531T 32" TV

1 Answer

Lacking red


in this case you have defective CRT Circuit System, CRT means The Cathode Ray Tube... Circuit system. this need to diagnose the System IC. if you know how to repair electronics appliances i can teach you how to fix this issue..


Jan 14, 2009 | RCA F32695BC 32" TV

2 Answers

RCA 32" wont turn on

It sounds like you may have a bad Horizontal Output Transistor (HOT) and/or a bad Flyback Transformer. The set is trying to start as indicated by the flashing light, but an internal fault is shutting it down right away. It could also be the Power Supply circuit. A 32in. set is not cheap to replace so it may be worth finding a repair technitian and at least getting a quote. The Flyback is the most expensive part, the others are minimal. If it is one of the above problems it could easily be repaired by a qualified technitian.

Mar 11, 2008 | RCA F32650 32" TV

1 Answer

32 RCA makes popping sounds

It needs a new FLY BACK transformer. That is what you are looking at. The origionals are not made for the set any longer but insist on having a generic on installed by a local TV shop. I just put one into a RCA 31" and it works nice. Don't throw away the TV. Get it fixed. MAKE SURE YOU INSIST THEY USE THE GENERIC ONE! THEY DO WORK!

Sep 15, 2007 | RCA E13320 13" TV

1 Answer

RCA 32V420T 32" TV

This RCA set uses the CTC187BD chassis. Look on the back of the set and to the right of the cable connector you will see 2 controls sticking out, one on top of the other. The top control is for focus and the bottom one is screen, or overall brightness. If these controls have been turned clockwise then you will have a bright, fuzzy picture with white lines (retrace lines) through it. Tune in a channel with white letters on the screen and turn the top (focus) control until the letters are crisp and sharp. Go into the menu and turn the contrast and brightness all the way down, and then turn the bottom control (screen) until you can just see the picture, just above the point where the picture is too dark to see. Go back into the menu and reset the contrast and brightness and the picture will be back to perfect.

Jun 28, 2007 | RCA 32V420T 32" TV

Not finding what you are looking for?
RCA F32650 32" TV Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66552 Answers

John mullen

Level 2 Expert

229 Answers


Level 3 Expert

2963 Answers

Are you a RCA Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides