Question about iLO 3200 32 in. LCD Television

1 Answer

Tv. wont turn on

I have an ilo flat screen its only two yrs. old and we have neer had problems and now its not turning on, when we try to turn it on, it makes weird nosies and then I hear the speaker pop and it does nothing! Can someone help? Any suggestions?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,361 Answers

Look at the power supply first since it is easier to get to, look for burnt parts, bad capacitors, etc.
http://en.wikipedia.org/wiki/Capacitor_plague
Please post back what you find.

Posted on Dec 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an ilo 32" TV less than 2 yrs old and last night it was fine. Now its on and I can hear the channels but the tv screen is black with hints of color outlining say people. DId a bulb blow?


LCD's don't have bulbs, they have CCFL tubes and they don't burn out. You have a fault in the inverter board that is powering the tubes - you will need to take the tv to a repair shop to have the board replaced.

Sep 22, 2010 | iLO 3200 32 in. LCD Television

3 Answers

Tv wont turn on


hmmm...ok...turn it off for around 20 minutes, to allow all energy to discharge. Then try it once again.

second...check to see that the power from wall is still good(always helps to check that)

Feb 24, 2008 | iLO 2600 Television

1 Answer

26 in. ilo lcd power button wont turn set on it flickers set about 2 yrs old


May be power supply problem, need to do some voltage checking.
If you are going to DIY and have proper tools and know safety precaution then please read on:

Please see my basic troubleshooting guide here:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide

http://s807.photobucket.com/home/budm/allalbums

http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com

Jun 29, 2010 | iLO 3200 32 in. LCD Television

2 Answers

Ilo tv won't turn on at monitor/set or via remote


Bad parts on your power supply board need testing and replacing....when you get the tv serviced be sure to tell the technician to install higher quality parts. ILO tends to use low-grade components that warp very quickly as their not designed to handle excessive heat for long periods of time. This is a very common problem with ILO and Akai tv's....

if the tv is under warranty take it back...

Nov 05, 2009 | iLO 2600 Television

2 Answers

ILO plasma and it won't power on. I have


unplug the tv lay the tv face down on a soft non scratch surface like a bed remove all the screws remove the back cover and, look for the words or a label with an arrow and, the warning "replace only with same size fuse" or, the designation F1, F2 etc.most tv's still use the familiar glass fuses; test and / or, replace the fuse(s)

Apr 27, 2009 | iLO 3200 32 in. LCD Television

1 Answer

ILO 2706 TV WONT TURN ON


This TV might have been affected by the power outage even if it was not ON at that moment. There is a standby voltage still present even when OFF and connected to the AC line.
There might be different failures on this TV:
1. The power supply might be defective after the power outage.
2. The main board could also be defective since the power supplies for today's TVs are not well regulated and once the voltage getting to the power supply increases, the standby voltage voltage will also increase damaging voltage sensitive components like the microprocessor or memory circuitry.

Let me know if you require further assistance.

Dec 18, 2008 | iLO 2600 Television

1 Answer

Tv wont turn on


Is it plasma , or LCD?

Feb 16, 2008 | iLO 2600 Television

4 Answers

Has power won't turn on


I have a Akai LCT3701AD 37 in. LCD, the sound comes on, but the screen just is blue

Feb 14, 2008 | iLO 2600 Television

1 Answer

ILO 32inch TV


ILO 32" lcd hdmi tech support Eastern Time
8:30 am - 9:00 pm (monday through friday)
9:00 am - 5:00 pm (saturday)
1-800-428-1105

my 8 month old tv doesnt even turn blue. just blinking red light where on/off light display appears. very discouraged cause wallmart will not help. trying techsupport. i found this number from my purchase paperwork. hope it is helpfull to you.

Dec 10, 2007 | iLO 3200 32 in. LCD Television

Not finding what you are looking for?
iLO 3200 32 in. LCD Television Logo

Related Topics:

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top iLO Televison & Video Experts

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Jaime Hernandez

Level 3 Expert

2336 Answers

Jim Goldsmith
Jim Goldsmith

Level 3 Expert

2005 Answers

Are you an iLO Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...