How do i set the clock on my kenwood kdc-mp5032?

See the instructions on page 18 of this manual.

como le hago si no tengo el control como configurar

Hi there,

Kenwood utilize the CD Changer plug in the back (which acts as a secondary Aux input), to operate external iPod devices.

This is done with the aid of an Adapter Lead - it has the 13-pin DIN plug on one end (plugs into the rear of your unit), and an iPod plug on the other end (plugs into your iPod).

Depending on the "Generation" of your external iPod device, you will need to buy the appropriate Kenwood adapter cable. These are: KCA-IP102, KCA-IP202 or KCA-IP302.

There may be some aftermarket (3rd party) cables that may do the same job.

Just ensure you read your Kenwood manual, as the Kenwood unit may be limited to the types of files (i.e. formats) it can read & play.

Hope this explains....

Cheers,

the usual colours are:

• black - ground
• blue - power ant
• blue/white - remote power on
• yellow - +12v
• red - accessory
• orange - illumination
• white - left front
• gray - right front
• green - left rear
• purple - right rear

on the speaker ones the colours with a black strip are usually the negative -

hope ths helps

You can buy a thing(not sure of exactly what its called) that you plug into your iphone and you pick a radio station on it and turn your stereo to that same station and listen to your itunes

http://www.kenwoodusa.com/UserFiles/File/Global/Consumer/Manuals/KDC-135.pdf Here's the manual link from Kenwood and it's on page 13. Hope this helps

Unfortunatel KENWOOD codes are not available for free from anywhere on the Internet.

Main Dealer or a Decoding Service only

sometimes get a push button says display push it

In your Instruction Manual you will find the steps for setting the clock for your unit. Please refer to the MENU section of your manual. Please note, to be able make specific setup changes to your KENWOOD unit you must do them while you are in the “MENU MODE”.

· First, press the SRC button repeatedly until it displays STANDBY.
· Then hold down the Menu button until MENU is displayed.
· Next press up or down on the right control knob, to scroll up or down, until the display reads “Clock Adjust” (CLK ADJ)
· Next press in the control knob, like a button, until the time starts flashing.
· Use the right control knob to adjust the setting; Up/Down adjusts hours, Left/Right adjusts minutes.
· Now press the Menu button to exit.

well i have the radio kdc-mp5032 an i have the remote but its askin me for a code an the place that i got it installed at closed down an i dont got the code any more how code i unlock my radio code