Hi, I have wirlpool washing machine awa 8125,The tombour is blocked, we hear a noise when it turns

Check the spring rods on each corner make sure not broken or came off pull basket make sure nothing in between silly question is it level also check the balance ring to make sure it is not loose

It is so common that the washing machine can make terrible noise in many ways and is a common fault. In all occasions it is important that your observation is most important and so is vital to the identification /rectification and solution. If you have noticed that machine is vibrating when it is running then the motor /drum suspension has to be inspected. Since these fittings are located on the underside of the machine it is important that you look for the noise with a good inspection lamp. Manually turn the motor and drum and listen for the noise, if so the motor bearings, the drum agitator shaft and fittings must be checked. Also the suspensions which include the shock absorbers and springs, the body clamps must be checked to be in correct alignment and not changed in position. Tightening of the mounting is also very important. Finally in most cases a drop of OIL or smear of grease on the moving parts cane solve most issues.

Check this link :

http://www.espares.co.uk/advice/washing-machines/a/7/1210/wobbly-washing-machine-or-tumble-dryer.html

For replacement of bearings check for tips on this visual link: http://www.espares.co.uk/advice/washing-machines/a/7/1401/how-to-replace-the-bearings-on-a-washing-mach.html

hi, it sounds like the brushes on the motor 2 plastic blockes sit either side of the motor thses are made of carbon and wear down can cause the motor to stop working hope it helps

regards
shaun

it proberly your cold water valve or the hose filter blocked. when its on rinse lisen at the back where the cold pipe goes into your machine and see if you can hear a buzing noise if you can its blocked take off and clean if you cant hear anything the inner cold valve has gone

It is most likely either the belt or the idlers which the belt wraps around. Open the top (disconnect first) and have someone turn the drum while you watch to see if the belt is slipping.
I hope I have been of help but please do not hesitate to ask if you have any further questions.
I appreciate your vote if you appreciate my reply.

You would hear the bearings in the spin cycle if it was them ....it would sound like you are at the airport...you will probably find that a bra wire has caught itself inbetween the drum and the tub and is scratching as it goes around.

IF WIRLPOOL LID SWITCH

You can call AWA Telefix in AU 1300 366 144

This is their on line order page
https://aware.awa.com.au/en/japi

Here is the parts that they list online
http://aware.awa.com.au/parts/NEC/WASH/NFL855/index.html

Once you contact them they should be able to help you.

Cheers Mate!

If you can hear the motor working but the agitator does not move, then it is the "coupling".

Let me know if you need more information.
Ash

Without being there to physically see what it's doing or hear the sound, I would say there's 3 possibilities. 1) drive block is slipping on basket drive / brake assembly. 2) basket drive assembly is worn where drive block seats onto it. 3) clutch slipping.