I have a orion 26 RTC MONITOR. THE POWER BUTTON USUALLY IS RED WHWN OF AND GREEN WHWN ON. NOW IT DOES NOT TURN ON AT ALL BUT THE POWER LIGHT IS YELLOW. PLEASE HELP

If power button is on (not blinks) and two red lights are blinking alternatively it means the inkpads are end of life. Ask epson service centre to reset it and replace the ink pad. You can go for wic reset with fees.

If power button is blinking with two red lights, it means your printer cannot initialize. Its a fatal error. Ask epson service engineer to service it.

You can try to do the monitor self test.
Monitor Self Test:
1. Physically test the monitor autonomously from the computer.2. Switch both the monitor and the computer off, and then disconnect the VGA cable le from the computer.3. Turn the monitor on, pressing the power button for about three seconds. The self-test screen will come up .4. If the image is clear, bright, and shows red, green, and blue, the monitor is working properly. Video issues may be due to the video resolution in the computer, and not the monitor.5. If the image is not apparent and intense or the colors are not accurate, then the trouble is with the monitor or some of the (OSD) settings. In this case, test your particular monitor's information for OSD.
It is always important to check the color of your power light for so you can distinguish if the monitor is defective. Getting red lights on the the power panel states that the power section of the monitor is faulty.

call sears they charge $99 to come out free estimate. mine was $300 fix. get your estimate and go from there good luck

Hello,

My LOEWE CAL 232 will not power up. When the power button is pressed, the monitor turns on, with the LOEWE on the monitor, then the TV continues with the previous activity (antenna, DVD, VCR etc.). Now all that happens is

1. the red light comes on

2.after about 1 second the green light turns on for about 12 seconds

3. the the green light turns off for about 1 second

4. then the green light turns on again for about 12 seconds

and this continues until the power button is pressed to turn the TV off. During this time, the monitor does not turn on and the only sound I hear seems to eminate from the power button.

Any thoughts?

mcdevito75 here, The red power light usually means the monitor is off, if when you press the red button it turns to green, or blue then the red power button means the monitor was off. Your monitor could be burned out.

A reddish picture is the classic symptom of worn out backlight bulbs.
Sensor circuits usually shut down the power to the bulbs in a second or so.
Monitor Mike.

Symptoms of a Defective or dying Power supplies on LCD TVs.
1. Light(s) on the front panel are behaving not normal example, blinking, amber color or
not steady, fainting, etc.
2. TV not turning ON properly.
3. TV turns OFF by itself.
4. Needs to be unplug to many times to make it work.
5. Humming or high pitch noise heard through speakers or at the back of the TV.

I repair these power supplies. Write to [email protected] if you require further assistance.

It could be that the CMOS battery is dead; that's what keeps your BIOS 'ready to go', and the power button just wakes up the power supply and the motherboard. If the CMOS battery (looks like a shiny silver coin on the motherboard) goes dead, the computer won't boot up at all. It's usually a CR2032 battery; carefully pry it out with a small screwdriver and replace it...you can find them at most drugstores, Radio Shack, etc.

Just click below for more information;

http://www.geekswhoknow.com/articles/reasons_you_get_a_blank_screen.htm

Hope this may help;

Regards,
VOTIT